Users Manual

FCC ID: T2C-BT50

Users Manual

Download: PDF
FCCID_4245530

USB Speakerphone CP900 English | 简体中文 Quick Start Guide (V1.0) www.yealink.com

Package Contents CP900 Zipper Bag Quick Start Guide Charging Your CP900 Connect the CP900 to a USB power source. The CP900 battery lasts for up to 12 hours of talk time and 3 hours to fully charge. PC Viewing the Battery Status Tap to view the battery status.

Connecting Your CP900 Connect to the mobile phone Hold the Bluetooth button for 2 seconds and pair to your smartphone. The bluetooth range is 10m. To disconnect or reconnect, tap the Bluetooth button again. Connect to PC via Bluetooth Connect the CP900 into a USB port on your PC. The CP900 and the BT50 are pre-paired and ready to use out of the box. The bluetooth range is 30m. For the CP900 to work correctly you may need to set the CP900 as the playback device in your operating system’s audio settings. PC Connect to PC via USB Cable For the CP900 to work correctly you may need to set the CP900 as the playback device in your operating system’s audio settings. PC

Place Your CP900 Position the speakerphone in the center of the table, up to 2m/6ft from each participant. A single CP900 is ideal for up to 6 people. PC Using Your CP900 Task Do Power on or off Long tap for 3 seconds Answer a call Tap End or reject a call Tap Volume up/down During a call, tap / Mute/unmute microphone During a call, tap Hold a call During a call, tap Connect Bluetooth device Tap Reset to the factory Hold and for 6 seconds.

包装清单 CP900 拉链包 快速入门指南 充电 使用USB线缆把CP900接入USB电源。CP900电池可支持12小时通话时长，充满电大约 需要3小时。 PC 检查电量 按 查看电池电量状态。

连接CP900 连接至移动电话 长按蓝牙键 2S，蓝牙处于配对模式，然后与手机进行配对。蓝牙距离为10米。 如果要断开蓝牙连接或重新连接，再按蓝牙键 。 通过蓝牙连接至PC 将BT50插入电脑的USB接口。BT50与CP900已预先配对，开箱即可使用。蓝牙距离为 30米。 注意你需要在操作系统的音频设置中将CP900设为播放设备。 PC 通过USB线连接至PC 注意你需要在操作系统的音频设置中将CP900设为播放设备。 PC

摆放位置 将CP900放在桌子中间，与每名与会者的距离不超过 2 米/6 英尺。一台 CP900可供 6 人使用。 PC 使用CP900 任务 操作 开机/关机 长按电源键 3秒 接听电话 按接听电话键 挂断/拒接电话 按挂断电话键 音量调高/调低 通话中，按音量调高 /调低键 麦克风静音/取消静音 通话中，按静音键 通话保持 通话中，按接听电话键 连接到蓝牙 按蓝牙键 按住接听电话键 和挂断电话键 恢复出厂 6秒钟

If the device is left unused for a rather long time, disconnect it from the Regulatory Notices power supply and unplug the power plug. When there is smoke emitted from the device, or some abnormal noise Operating Ambient Temperatures or smell, disconnect the device from the power supply, and unplug the Operating temperature: +32 to 104°F (0 to 40°C) power plug immediately. Relative humidity: 5% to 90%, noncondensing Contact the specified maintenance center for repair. Storage temperature: -22 to +160°F (-30 to +70°C) Do not insert any object into equipment slots that is not part of the Warranty product or auxiliary product. Our product warranty is limited only to the unit itself, when used normally Before connecting a cable, connect the grounding cable of the device in accordance with the operating instructions and the system environment. first. Do not disconnect the grounding cable until you disconnect all other We are not liable for damage or loss resulting from the use of this product, cables. or for any claim from a third party. We are not liable for problems with CAUTION: Risk of explosion if battery is replaced by an incorrect type. Yealink device arising from the use of this product; we are not liable for Warning : financial damages, lost profits, claims from third parties, etc., arising from To avoid replacement of a battery with an incorrect type the use of this product. Don't disposal of a battery into fire or a hot oven, or mechanically crushing or. Explanation of the symbols cutting of a Battery. Don’t leaving a battery in an extremely high temperature surrounding environment DC symbol To avoid battery subjected to extremely low air pressure. is the DC voltage symbol. The marking information is located at the bottom of apparatus WEEE Warning symbol FCC Statement To avoid the potential effects on the environment and human health This device complies with part 15 of the FCC Rules. Operation is subject to the as a result of the presence of hazardous substances in electrical and following electronic equipment, end users of electrical and electronic two conditions: (1) this device may not cause harmful interference, and (2) this equipment should understand the meaning of the crossed-out wheeled bin device must accept any interference received, including interference that may symbol. Do not dispose of WEEE as unsorted municipal waste and have to cause undesired operation. collect such WEEE separately. Any Changes or modifications not expressly approved by the party responsible Restriction of Hazardous Substances Directive (RoHS) for compliance could void the user's authority to operate the equipment. This device complies with the requirements of the EU RoHS Directive. NOTE: This equipment has been tested and found to comply with the limits for a Class B Statements of compliance can be obtained by contacting support@yealink.com. digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide Safety Instructions reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed Save these instructions. Read these safety instructions before use! and used in accordance with the instructions, may cause harmful interference to radio General Requirements communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or Before you install and use the device, read the safety instructions television reception, which can be determined by turning the equipment off and on, the carefully and observe the situation during operation. user is encouraged to try to correct the interference by one of the following measures: During the process of storage, transportation, and operation, please - Reorient or relocate the receiving antenna. always keep the device dry and clean, avoid collision and crash. - Increase the separation between the equipment and receiver. Please attempt not to dismantle the device by yourself. In case of any discrepancy, please contact the appointed maintenance center for repair. to which the receiver is connected. Please refer to the relevant laws and statutes while using the device. - Connect the equipment into an outlet on a circuit different from that Legal rights of others should be respected as well. - Consult the dealer or an experienced radio/TV technician for help. Environmental Requirements IC Statement Place the device at a well-ventilated place. Do not expose the device This device complies with Industry Canada’s licence-exempt RSSs. Operation is under direct sunlight. subject to the following two conditions: Keep the device dry and free of dusts. (1) this device may not cause interference; and Do not place the device on or near any inflammable or fire-vulnerable (2) this device must accept any interference, including interference that may object, such as rubber-made materials. cause undesired operation of the device. CAN ICES-3(B) Keep the device away from any heat source or bare fire, such as a candle Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux or an electric heater. appareils radio exempts de licence. L’exploitation est autorisée aux deux Operating Requirements conditions suivantes : Do not let a child operate the device without guidance. (1) l’appareil ne doit pas produire de brouillage; Do not let a child play with the device or any accessory in case of (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, accidental swallowing. même si le brouillage est susceptible d’en compromettre le Please use the accessories provided or authorized by the manufacturer fonctionnement.NMB-3(B) only. The power supply of the device shall meet the requirements of the input voltage of the device. Please use the provided surge protection power socket only. Before plugging or unplugging any cable, make sure that your hands are completely dry. Do not spill liquid of any kind on the product or use the equipment near water, for example, near a bathtub, washbowl, kitchen sink, wet basement or near a swimming pool. During a thunderstorm, stop using the device and disconnect it from the power supply. Unplug the power plug and the Asymmetric Digital Subscriber Line (ADSL) twisted pair (the radio frequency cable) to avoid lightning strike. About Yealink Yealink is a global leading provider of enterprise communication and collaboration solutions, offering video conferencing service to worldwide enterprises. Focusing on research and development, Yealink also insists on innovation and creation. With the outstanding technical patents of cloud computing , audio, video and image processing technology, Yealink has built up a panoramic collaboration solution of audio and video conferencing by merging its cloud services with a series of endpoints products. As one of the best providers in more than 140 countries and regions including the US, the UK and Australia, Yealink ranks No.1 in the global market share of SIP phones shipments. Technical Support Visit Yealink WIKI (http://support.yealink.com/) for the latest firmware, guides, FAQ, Product documents, and more. For better service, we sincerely recommend you to use Yealink Ticketing system (https://ticket.yealink.com) to submit all your technical issues. YEALINK(XIAMEN) NETWORK TECHNOLOGY CO.,LTD. Web: www.yealink.com Copyright©2019 YEALINK(XIAMEN) NETWORK TECHNOLOGY CO.,LTD.All rights reserved. CP900- EN+CN


Document Created: 2019-01-23 09:47:58
Document Modified: 2019-01-23 09:47:58
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC