Limited Modular approval letter

FCC ID: S9E-NOMADWAN

Cover Letter(s)

Download: PDF
FCCID_952162

TRIPOD DATA SYSTEMS, INC. 345 SW Avery Ave. Corvallis, OR 97333 April 28, 2008 Dear Application Examiner: Tripod Data Systems’ Handheld Nomad PDA with internal GSM/GPRS/EDGE radio, M/N: MC75, is seeking limited modular approval under the FCC ID: S9E- NOMADWAN. The radio meets the requirements for limited modular approval as detailed in FCC Public Notice DA00-1407. Compliance or non-compliance to each of the modular approval requirements is described below: 1. “The modular transmitter must have its own RF shielding.” The radio portion of the module is contained in its own RF shielding. Please see the MC75 Hardware Interface Description exhibit. 2. “The modular transmitter must have buffered modulation/data inputs.” The MC75 Hardware Interface Description provides means for the OEM to buffer inputs. 3. “The modular transmitter must have its own power supply regulation.” The IC contains low drop linear voltage regulators to handle the power management of the chip. It requires an input voltage of 3.2V to 4.3V which is provided by the Tripod NOMAD. 4. “The modular transmitter must comply with the antenna requirements of Section 15.203 and 15.204(c).” The EUT meets the FCC antenna requirements. Please see Antenna information exhibit and internal photos exhibit. 5. “The modular transmitter must be tested in a stand-alone configuration.” The EUT was not tested in a stand-alone configuration. The radio was tested while installed in Tripod’s Nomad handheld computer. Therefore, the radio does not comply with the requirements for full modular approval. Thus, Tripod Data Systems is seeking limited modular approval. 6. “The modular transmitter must be labeled with its own FCC ID number.” The Nomad will be labeled with its own FCC ID number for the GSM/GPRS/EDGE radio. Please see the FCC ID label & location exhibit.

7. “The modular transmitter must comply with any specific rule or operating requirements applicable to the transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements.” The EUT is compliant with all applicable FCC rules. Detail instructions for maintaining compliance are given in the User Manual. 8. “The modular transmitter must comply with any applicable RF exposure requirements.” The EUT is compliant with all applicable RF exposure requirements. Please see the RF Exposure exhibit. Please contact us if you have additional questions. Your attention to this matter is greatly appreciated. Best regards,


Document Created: 2008-06-04 11:03:14
Document Modified: 2008-06-04 11:03:14
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC