Modular approval letter

FCC ID: S8J-R8188EU1F

Cover Letter(s)

Download: PDF

FCCID_2866659

Shenzhen Bilian Electronic Co., Ltd.

(Date) 01/05/2016

150Mbps Wireless N USB Module FCC ID : S8J-R8188EU1F ,
is seeking FCC Authorization as a Single Modular transmitter / Single Limited Modular Approval (Please check one).
The EUT meets the requirements for Single Modular approval / Single Limited Modular Approval (please check one)
as detailed in FCC public Notice DA00-1407. Compliance to each of the requirements is described below:

Questions are: * Please provide a detailed explanation if the answer is “No.”

Item Modular requirement Yes No
1 The radio elements must have the radio frequency circuitry shielded. Physical components and tuning √
capacitor(s) may be located external to the shield, but must be on the module assembly;

Details: The EUT is non-shielded part.

2 The module must have buffered modulation/data inputs to ensure that the device will comply with Part √
15 requirements with any type of input signal;

3 The module must contain power supply regulation on the module; √

Details: The module can be powered by the external host.

4 The module must contain a permanently attached antenna, or contain a unique antenna connector, and √
be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), 15.204(c),
15.212(a), 2.929(b);

5 The module must demonstrate compliance in a stand-alone configuration; √

Details: The module can’t stand-alone work, It must be insert on a host device

6 The module must be labelled with its permanently affixed FCC ID label, or use an electronic display √
(See KDB Publication 784748 about labelling requirements);

7 The module must comply with all specific rules applicable to the transmitter including all the conditions √
provided in the integration instructions by the grantee;

8 The module must comply with RF exposure requirements √
Note:
(1) LMA may be granted when one or more of the requirements in the table above cannot be demonstrated.
LMA will also be issued in those instances where applicants can demonstrate that they will retain control over the final installation of the device, such that compliance of the
end product is assured. In such cases, an operating condition on the LMA for the module must state that the module is only approved for use when installed in devices
produced by a specific manufacturer.
When LMA is sought, the application for equipment certification must specifically state how control of the end product into which the module will be installed, and will be
maintained, such that full compliance of the end product is always ensured.
(2) Please provide Clear and specific instructions describing the conditions, limitations and procedures for third-parties to use and/or integrate the module into a host device.
(3) For non-Software Defined Radio transmitter modules where software is used to ensure compliance of the device, technical description of how such control is implemented
to ensure prevention of third party modification must be provided (see KDB 594280).

Note 1: Compliance of a module in its final configuration is the responsibility of the applicant. A host device will not be considered certified if the instructions regarding antenna
configuration provided in the original description, of one or more separately certified modules it contains, were not followed.
Example: A separately certified low-power transceiver module using Bluetooth technology which is housed in a desktop computer, laptop or peripheral does not require the overall
system to be recertified, if the desktop computer, laptop or peripheral, as a stand-alone unit, complies with all applicable technical standards.

SCS-F26 Modular Approval Letter Page 2 of 3 Rev 10.0

Document Created: 2016-01-07 17:04:05
Document Modified: 2016-01-07 17:04:05

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC