Modular Appr Req. Letter

FCC ID: RX3-WFU033

Cover Letter(s)

Download: PDF
FCCID_3836957

Applicant/Grantee Hon Hai Precision Industry Co., Ltd. FCC ID: RX3-WFU033 Section 15.212 Modular Transmitters X Request for Modular Approval Request for Limited Modular Approval Requirements Device Conditions Comply (Y/N) Single Modular Approval Requirements The radio elements must have the radio The module has its own RF shielding.” frequency circuitry shielded. Shield Can is employed on the board Physical/discrete and tuning capacitors structure, please see exhibition External 1 Y may be located external to the shield, but Photo, the emission measurement was must be on the module assembly. conducted without further shielding added. The module shall have buffered All modulation and data input(s) are modulation/data input(s) (if such inputs are buffered.” The EUT has buffered data provided) to ensure that the module will inputs, it is integrated on the RF chip 2 comply with the requirements set out in the Y applicable RSS standard under conditions of excessive data rates or over-modulation. The module shall have its own power Output power is controlled by the RF supply regulation on the module. This is to Chip and de-coupled from supply ensure that the module will comply with voltage variations. the requirements set out in the applicable Frequencies are determined by Crystal standard regardless of the design of the 3 power supplying circuitry in the host Y device which houses the module. Requirements set out in the applicable standard regardless of the design of the power supplying circuitry in the host device which houses the module. The module shall comply with the The EUT meets the FCC antenna provisions for external power amplifiers Requirements. and antennas detailed in this standard. The PCB Antenna soldered on board 4 Equipment certification submission shall Y contain a detailed description of the configuration of all antennas that will be used with the module. The module shall be tested for compliance The modular transmitter was tested in a with the applicable standard in a stand- stand-alone configuration via a SPI alone configuration, i.e. the module must Interface. 5 Y not be inside another device during testing. The modular transmitter must be In the exhibition OEM manual, there are equipped with either a permanently affixed Instructions given to the OEM on how to 6 Y label. label the end product.

The modular transmitter complies with all Instructions in User Manual specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer will 7 provide adequate instructions along with Y the module to explain any such requirements. A copy of these instructions is included in this application for equipment authorization: Address compliance with the Please refer the Maximum Permissible Commission's RF exposure limits in Exposure Information. Sections 1.1310 and 2.1093. In addition, spread spectrum transmitters operating 8 Y under Section 15.247 are required to address RF exposure compliance in accordance with Section 15.247(b)(4). A limited modular approval may be granted for single or split modular transmitters that do not comply with all of the above requirements, e.g., shielding, minimum signaling amplitude, buffered modulation/data inputs, or power supply regulation, if the manufacturer can demonstrate by alternative means in the application for equipment authorization that the modular transmitter meets all the applicable Part 15 requirements under the operating conditions in which the transmitter will be used. Limited modular approval also may be granted in those instances where compliance with RF exposure rules is demonstrated only for particular product configurations. The applicant for certification must state how control of the end product into which the module will be installed will be maintained such that full compliance of the end product is always ensured. Signature Name/Title: Cathy Kuo / Supervisor Company Name: Hon Hai Precision Industry Co., Ltd. Date: April 12, 2018


Document Created: 2018-04-12 19:58:51
Document Modified: 2018-04-12 19:58:51
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC