Response 2

FCC ID: RS2SA10101B

Cover Letter(s)

Download: PDF
FCCID_713937

Response to ATCB comments of 10-3-2006 regarding RS2SA10101B.


1) The antenna position photograph shows FCC ID No, instead of FCC ID:. Please confirm
sample label is using correct nomenclature of "FCC ID:".

Answer: The 'label position' photograph was intended to show label location only. The new
drawing file ,SKYFi2Label Artwork New FCC rev3.pdf' has been uploaded showing the proper
FCC ID nomenclature.

2) The revised test report is requesting short term confidentiality. Please note that this is not
allowed (confidentiality is not allowed on test reports).

Answer: Noted.

3) Test photographs are integrated into the most recent updated report. Note that these should
only be provided as a separate exhibit, especially if confidentiality is requested on the photos.
Please correct the report.

Answer: A new report, SkyFi2 Report_of_Measurements6.pdf' has been uploaded, along with a
new test setup photos document, 'SkyFi2_Report_of_Measurements test set up photos3.pdf.'

4) The ferrite shown in the manual on some accessories appears to be snap on. Please note that
he FCC requires this to be installed in a fashion that is permanent (i.e. molded, shrink wrapped,
etc.). Providing a snap on ferrite that can be removed is not allowed. Please review. Note that
page 5 suggests snap on, while page 18 suggests permanent.

Answer: Ferrites are shrinkwrapped into the power cable.



Document Created: 2006-10-04 17:06:39
Document Modified: 2006-10-04 17:06:39

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC