test report 15C part 2

FCC ID: RRK2004042018-1

Test Report

Download: PDF
FCCID_449547

FCC ID: RRK2004042018-1 CH6 Report No.: RF930503L04 51 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 CH11 Report No.: RF930503L04 52 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 4.5.7 TEST RESULTS-OFDM EUT IEEE802.11g Wireless Access Point ENVIRONMENTAL 27 deg. C, 59%RH, MODEL DWL-2200AP CONDITIONS 968 hPa INPUT POWER 120Vac, 60 Hz TESTED BY Tony Chen (SYSTEM) CHANNEL RF POWER LEVEL IN MAXIMUM CHANNEL FREQUENCY 3 KHz BW LIMIT PASS/FAIL NUMBER (MHz ) (dBm) (dBm) 1 2412 -10.08 8 PASS 6 2437 -6.31 8 PASS 11 2462 -9.58 8 PASS Turbo 6 2437 -10.35 8 PASS Report No.: RF930503L04 53 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 CH1 Report No.: RF930503L04 54 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 CH6 Report No.: RF930503L04 55 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 CH11 Report No.: RF930503L04 56 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 Turbo CH6 Report No.: RF930503L04 57 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 4.6 BAND EDGES MEASUREMENT 4.6.1 LIMITS OF BAND EDGES MEASUREMENT Below –20dB of the highest emission level of operating band (in 100KHz Resolution Bandwidth). 4.6.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until R&S SPECTRUM ANALYZER FSP40 100036 Nov. 27, 2004 NOTE: 1.The measurement uncertainty is less than +/- 2.6dB, which is calculated as per the NAMAS document NIS81. 2.The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. 4.6.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer via a low lose cable. Set both RBW and VBW of spectrum analyzer to 100 kHz with suitable frequency span including 100 kHz bandwidth from band edge. The band edges was measured and recorded. 4.6.4 EUT OPERATING CONDITION Same as Item 4.3.5 Report No.: RF930503L04 58 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 4.6.5 TEST RESULTS –DSSS The spectrum plots are attached on the following 2 pages. D1 line indicates the highest level, D2 line indicates the 20dB offset below D1. It shows compliance with the requirement in part 15.247(C). Note - The delta method is only used up to 2 MHz away from the restricted bandage, The radiated emissions which located in other restricted frequency band, the result, please refer to 4.2. NOTE (1): The band edge emission plot on the following first page shows 58.74dB delta between carrier maximum power and local maximum emission in restrict band (2.3900GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2 is 107.50dBuV/m, so the maximum field strength in restrict band is 107.50-58.74=48.76dBuV/m which is under 54 dBuV/m limit. NOTE (2): The band edge emission plot on the following second page shows 59.18dB delta between carrier maximum power and local maximum emission in restrict band (2.4835GHz). The emission of carrier strength list in the test result of channel 11 at the item 4.2. is 108.80dBuV/m, so the maximum field strength in restrict band is 108.80-59.18=49.62dBuV/m which is under 54 dBuV/m limit. Report No.: RF930503L04 59 Issued: Jun. 18, 2004

1—8 LOTFOFPOOTNE ‘CI D FoT80s08e4x on uoday *RBW 1 MHz Marker 4 [ Tl ] *VBW 300 Hz —51.91 dBm Ref 20 dBm *Att 10 dB SWT 840 ms 2.386800000 GHz 20 Offréet 20]5 dB Marker] 1}[ TL 678 dBm is 2l 4116000004168 D1 6.78| dBm Wendocar) —#4—4OW4 * —32,05 dBm m —apooutbpot cHz Marker| 3| [ T LVL ya 51196 dBm f pa —h2.38 abm 2l 3bopooboo cHz |——20 / |——30 09 € ——40 [~5° “*W}///ivJV |—B5—2 AvecviaherggeeNzafr* ——70 F2 ¥00z ‘gL ‘unp :ponss; Fl —80 Center 2.367 GHz 10 MHz/ Span 100 MHz

T—8 LOCFOFOOTNRRIT ‘CI D POTE05OE6—IA on uodex *RBW 1 MHz Marker 4 [ T1 ] *VBW 300 Hz —50 .96 dBm Ref 20 dBm *Att 10 dB SWT 840 ms 2.483600000 GHz 20 Offset 20|5 dB Marker| 1 [ TL 8122 dBm & 1 2l asiso0b00 cs 32 Xip1 s.22) dsm Marker| 2 [ TL —50196 dBm & ~t83500p00~GHz Marker| 3 [ TL LVL —56.43 dBm _‘__10 D2 _11'78 d m d_:nnnnn'\nn lelt ——28 22y L9 i——40 2 |——50 ww-"J"h /\_ ——60 ——70 F00z ‘g} ‘unp :ponss) ¥23 F1 —80 %<;§é§;y Center 2.503 GHz 10 MHz/ Span 100 MHz M¥

FCC ID: RRK2004042018-1 4.6.6 TEST RESULTS- OFDM The spectrum plots are attached on the following 2 pages. D1 line indicates the highest level, D2 line indicates the 20dB offset below D1. It shows compliance with the requirement in part 15.247(C). Note - The delta method is only used up to 2 MHz away from the restricted bandage, The radiated emissions which located in other restricted frequency band, the result, please refer to 4.2. NOTE (1): The band edge emission plot on the following first page shows 49.85dB delta between carrier maximum power and local maximum emission in restrict band (2.3900GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2. is 102.6dBuV/m, so the maximum field strength in restrict band is 102.6-49.85=52.75dBuV/m which is under 54 dBuV/m limit. NOTE (2): The band edge emission plot on the following second page shows 50.67dB delta between carrier maximum power and local maximum emission in restrict band (2.4835GHz). The emission of carrier strength list in the test result of channel 11 at the item 4.2. is 102.80dBuV/m, so the maximum field strength in restrict band is 102.80-50.67=52.13dBuV/m which is under 54 dBuV/m limit. Report No.: RF930503L04 62 Issued: Jun. 18, 2004

T—8 10CFOFO0T3RIA ‘CI D FO720808641X on uodey *RBW 1 MHz Marker 4 [ Tl ] *VBW 300 Hz —49.49 dBm Ref 20 dBm *Att 10 dB SWT 840 ms 2.390000000 GHz 20 Offiet 20]5 dB Marker] 1 [ TL 036 dBm Fio aisoonhoo cs Markep] 2 [ Tl ~34} 021 dBm =o D1._0..36) dfm C —apoutuubdo Cf Marker] 3 [ T1 ] Z\ LVL h —49149 dBm s . $90000000 GHz 0 p2 _—1.9..64 m |——30 €9 // zo ——50 //’V |——so sls **~— ——70 Fa F1 F007 ‘g£ ‘unp :panss| —80 Center 2.371 GHz 10 MHz/ Span 100 MHz Y

1—8 LOTFOFPOOTNE ‘CI D FoT80s08e4x on uoday *RBW 1 MHz Marker 4 [ TL ] *VBW 300 Hz —51.17 dBm Ref 20 dBm *Att 10 dB SWT 840 ms 2.483600000 GHz 20 Offfet 20|5 dB Marker| 1 [ Tl —0,50 dBm F16 2l assa00b00 cx Marker| 2 [ TL 1 —51117 dBm 9 . =U. 3f gBm EARUTTUY &2 k Marker| 3 [ TL LVL —57.93 dBm s 2| sooooopboo onz —=20 D réwag— ciB v9 ——30 ——60 ——70 ¥00z ‘gL ‘unp :ponss; x3 F1 —80 wuo> 1GV h7 Center 2.503 GHz 10 MHz/ Span 100 MHz >

FCC ID: RRK2004042018-1 4.7 ANTENNA REQUIREMENT 4.7.1 STANDARD APPLICABLE For intentional device, according to FCC 47 CFR Section 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. And according to FCC 47 CFR Section 15.247 (b), if transmitting antennas of directional gain greater than 6dBi are used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6dBi. 4.7.2 ANTENNA CONNECTED CONSTRUCTION The antennas used in this product are Dipole Antenna with R-SMA connector and printed antenna without connector. The maximum Gain of the antenna is 5.0dBi. Report No.: RF930503L04 65 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST (With Adapter) Report No.: RF930503L04 66 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 CONDUCTED EMISSION TEST (With POE) Report No.: RF930503L04 67 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 RADIATED EMISSION TEST (With Adapter) Report No.: RF930503L04 68 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 RADIATED EMISSION TEST (With POE) Report No.: RF930503L04 69 Issued: Jun. 18, 2004

FCC ID: RRK2004042018-1 6 INFORMATION ON THE TESTING LABORATORIES We, ADT Corp., were founded in 1988 to provide our best service in EMC, Radio, Telecom and Safety consultation. Our laboratories are accredited and approved by the following approval agencies according to ISO/IEC 17025, Guide 25 or EN 45001: USA FCC, NVLAP, UL Germany TUV Rheinland Japan VCCI Norway NEMKO Canada INDUSTRY CANADA , CSA R.O.C. CNLA, BSMI, DGT Netherlands Telefication Singapore PSB , GOST-ASIA(MOU) Russia CERTIS(MOU) Copies of accreditation certificates of our laboratories obtained from approval agencies can be downloaded from our web site: www.adt.com.tw/index.5/phtml. If you have any comments, please feel free to contact us at the following: Linko EMC/RF Lab: Hsin Chu EMC/RF Lab: Tel: 886-2-26052180 Tel: 886-3-5935343 Fax: 886-2-26052943 Fax: 886-3-5935342 Hwa Ya EMC/RF/Safety/Telecom Lab: Linko RF Lab. Tel: 886-3-3183232 Tel: 886-3-3270910 Fax: 886-3-3185050 Fax: 886-3-3270892 Email: service@mail.adt.com.tw Web Site: www.adt.com.tw The address and road map of all our labs can be found in our web site also. Report No.: RF930503L04 70 Issued: Jun. 18, 2004


Document Created: 2004-06-18 20:38:21
Document Modified: 2004-06-18 20:38:21
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC