MPE Report

FCC ID: RI7XE61

RF Exposure Info

Download: PDF
FCCID_1673932

Compliance with 47 CFR 2.1091 and 1.1310
The EUT is a wireless 2.4 GHz module manufactured by Telit Communications S.p.A. It was certified under FCC 15.247 as a DTS
device, FCC ID: RI7XE61. The EUT will only be used with a separation distance of 20 centimeters or greater between the antenna
and the body of the user or nearby persons and can therefore be considered a mobile transmitter per 47 CFR 2.1091(b). The antenna is
a ceramic patch antenna. The antenna has a maximum gain of 2 dBi. The maximum peak conducted output power is 119 mW.

The maximum peak radiated power (measured) is 188 mW (EIRP). Since the transmit frequency is greater than 1.5 GHz, and the
output power is less than 3 W ERP, the EUT is categorically excluded from routine environmental evaluation per 47 CFR 2.1091(c).
The MPE estimates are as follows:

Table 1 in 47 CFR 1.1310 defines the maximum permissible exposure (MPE) for the general population above 1.5 GHz as 1 mW/cm2.
The exposure level at a 20 cm distance from the EUT’s transmitting antenna is calculated using the general equation:

                 S = (PG)/4R2
                 Where: S = power density (mW/cm2)
                 P = power input to the antenna (mW)
                 G = numeric power gain relative to an isotropic radiator
                 R = distance to the center of the radiation of the antenna (20 cm = limit for MPE estimates)
                 PG = EIRP

Solving for S, the maximum power density 20 cm from the transmitting antenna is summarized in the following table:

 FCC ID: RI7XE61

                                                                                                                        General
                                                          Max Peak                        Minimum        Power
                Antenna    Antenna Part      Transmit                                                                  Population
 Antenna Type                                             Conducted     Antenna Gain      Antenna     Density @ 20
              Manufacturer     No.          Frequency                                                                Exposure Limit
                                                         Output Power                    Cable Loss       cm
                                                                                                                      from 1.1310
                                                                                                                2              2
                                               (MHz)         (mW)            (dBi)           (dB)       (mW/cm )       (mW/cm )

 Ceramic Patch    Taoglas      WPC25A          2400           119              2              0        0.03752123          1




The power density does not exceed 0.038 mW/cm2 at 20 cm; therefore, the exposure condition is compliant with FCC rules.



Document Created: 2012-04-06 15:57:17
Document Modified: 2012-04-06 15:57:17

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC