Test Report 2

FCC ID: RI7GE863

Test Report

Download: PDF
FCCID_690664

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter 2.5 Antenna Description No antenna is provided (or supplied to the market) together with the product. 11

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter 2.6 Conducted RF Power Output (FCC Section 2.1046) § 2.1046 Measurements required: RF power output. (a) For transmitters other than single sideband, independent sideband and controlled carrier radiotelephone, power output shall be measured at the RF output terminals when the transmitter is adjusted in accordance with the tuneup procedure to give the values of current and voltage on the circuit elements specified in § 2.1033(c)(8). The electrical characteristics of the radio frequency load attached to the output terminals when this test is made shall be stated. (b) For single sideband, independent sideband, and single channel, controlled carrier radiotelephone transmitters the procedure specified in paragraph (a) of this section shall be employed and, in addition, the transmitter shall be modulated during the test as follows. In all tests, the input level of the modulating signal shall be such as to develop rated peak envelope power or carrier power, as appropriate, for the transmitter. (c) For measurements conducted pursuant to paragraphs (a) and (b) of this section, all calculations and methods used by the applicant for determining carrier power or peak envelope power, as appropriate, on the basis of measured power in the radio frequency load attached to the transmitter output terminals shall be shown. Under the test conditions specified, no components of the emission spectrum shall exceed the limits specified in the applicable rule parts as necessary for meeting occupied bandwidth or emission limitations. 12

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter TABLE 3a CONDUCTED RF POWER OUTPUT 824 MHz to 848 MHz Range Frequency of Measurement Measurement Fundamental (dBm) (Watt) (MHz) 824.09 31.12 1.294 835.92 30.29 1.069 848.70 29.99 0.997 2.85dB added for cable and Attenuator loss Calculation: Antilog( 31.12/10 ) = 1.294 w Test Date: April 5, 2006 Tester Signature: Name: Austin Thompson 13

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3a. Conducted RF Power Output 14

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3b. Conducted RF Power Output 15

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3c. Conducted RF Power Output 16

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter TABLE 3b CONDUCTED RF POWER OUTPUT 1850 MHz to 1909 MHz Range Frequency of Measurement Measurement Fundamental (dBm) (Watt) (MHz) 1.85013 28.54 0.714 1.87990 26.37 0.433 1.90980 27.68 0.586 1.17dB added for cable and Attenuator loss Calculation: Antilog( 28.54/10 ) = 0.714 w Test Date: April 5, 2006 Tester Signature: Name: Austin Thompson 17

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3d. Conducted RF Power Output 18

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3e. Conducted RF Power Output 19

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter Figure 3f. Conducted RF Power Output 20

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter 2.7 Field Strength of Spurious Radiation (FCC Section 2.1053) Spurious emissions were evaluated from 30 MHz to 19.1 GHz at an EUT to antenna distance of 1 or 3 meters. The EUT was tested with an external power source and modulated by its own internal sources. A low, middle and high channel were tested. The EUT was placed on an open area test site and the spurious emissions tested as stipulated by EIT/TIA-603: 1992 section 2.2.12. Measurements for 30 to 1000 MHz were made with the analyzer's bandwidth set to 120 kHz. Measurements above 1 GHz were made with the analyzer's bandwidth set to 1 MHz. The worse case results are shown in Table 4a. Initial measurements were calculated to determine margin in dB from the Limit. Any margin less than 20dB was repeated using the substitution Method of EIA/TIA-603:1992 section 2.2.1.2. Substitution Method results are shown in table 4b. FCC Minimum Standard (FCC Section 24.238) On any frequency outside a licensee’s frequency block, the power of any transmission shall be attenuated below the transmitter power (P) by at least 43 + 10 log (P) dB. 21

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter TABLE 4a RADIATED RF POWER OUTPUT Radiated Emissions (Theoretical) Test By: Test: Substitution for Client: Sicom GM863 Quad Project: 06-0008 Class: B Model: Frequency Range Sicom Model S/N Valid Calibrated: 2HN3mH Model : SAS-571 S/N 605 Yes 01 APR 05 Frequency Test Data AF Test AF+CA- Results Limits Distance / Margin Data AMP (MHz) (dBm) Table (dBuV) (dB) (uV/m) (uV/m) Polarity (dB) 5550.40 -64.7 2HN3mH 42.3 8.1 331.0 16552.0 3m./HORZ 34.0 7400.95 -55.7 2HN3mH 51.3 11.0 1300.4 16552.0 3m./HORZ 22.1 9251.2 -61.2 2HN3mH 45.8 12.9 866.6 16552.0 3m./HORZ 25.6 11099.2 -59.2 2HN3mH 47.8 17.1 1745.1 16552.0 3m./HORZ 19.5 5729.1 -65.7 2HN3mH 41.3 8.5 308.5 16552.0 3m./HORZ 34.6 7639.1 -52.0 2HN3mH 55.0 11.2 2055.3 16552.0 3m./HORZ 18.1 9548.9 -60.4 2HN3mH 46.6 13.2 979.2 16552.0 3m./HORZ 24.6 11456.8 -59.9 2HN3mH 47.1 17.9 1768.4 16552.0 3m./HORZ 19.4 Test Date: February 27, 2006 Tester Signature: Name: Austin Thompson 22

U.S. Technologies, Inc. Test Report, FCC Part 24E and Part 22H Report Number: 06-0008 Issue Date: April 18, 2006 Customer: Sicom test s.r.l. Model: GE863-QUAD / GE863-PY Modular Transmitter TABLE 4b RADIATED RF POWER OUTPUT (Substitution) RF Power into TX Recreated antenna (Corrected RF Power into Reading During TX Gain Maximum RX Difference for any CL and substitution TX Margin Theoretical Substitution TX Gain Relative Limit Frequency Reading (Units Column A - Pads to antenna antenna corrected Below Margin Below (Using Same (dBi) to Dipole (dBm) A) B Feed Point) (dBm) by TX Gain Relative Limit (dB) Limit Units A) - Ideally (dB) to Dipole (dBm) 0 (SG Value-CL) The following applies information from test as performed on Model GM863 Quad 7639.1 -52 -51.67 -0.33 11.4 9.26 -46.03 -37.1 -13 24.1 18.1 Test Date: February 27, 2006 Tester Signature: Name: Austin Thompson 23


Document Created: 2019-10-30 08:17:41
Document Modified: 2019-10-30 08:17:41
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC