Modular Declaraion Letter

FCC ID: RI7CL865-DUAL

Cover Letter(s)

Download: PDF
FCCID_2234561

Date : Jan. 10, 2014 Rev : 2.1 Modular Approval Declaration Letter HCT America LLC HACS-F007 (TCB@hctamerica.com) Modular Approval Page 1 of 2 44364 S. Grimmer Blvd. Fremont, CA 94538 Declaration Letter TEL: +1.510.933.8848, Fax: +1.510.933.8849 This document is electronically controlled. Hard copy documents are uncontrolled. Please check all hard copies against the controlled electronic copy to ensure validity. This document is the confidential property of HCT America LLC. It may not be forwarded or reproduced in whole or in part without written permissions from HCT America LLC

Date : Jan. 10, 2014 Rev : 2.1 REVISION TABLE Rev Description of Change Date Approved 1.0 Original Release(Obsolete) 06/14/2012 QM 2.0 Updated Template(Obsolete) 10/01/2012 QM 2.1 Updated address 01/10/2014 QM HCT America LLC HACS-F007 (TCB@hctamerica.com) Modular Approval Page 2 of 2 44364 S. Grimmer Blvd. Fremont, CA 94538 Declaration Letter TEL: +1.510.933.8848, Fax: +1.510.933.8849 This document is electronically controlled. Hard copy documents are uncontrolled. Please check all hard copies against the controlled electronic copy to ensure validity. This document is the confidential property of HCT America LLC. It may not be forwarded or reproduced in whole or in part without written permissions from HCT America LLC

Via Stazione di Prosecco 5/B Trieste 34010, Italy Date: Mar. 17, 2014 Subject : Modular Approval Declaration Letter FCC ID : RI7CL865-DUAL is seeking FCC equipment authorization as Single Modular Transmitter Single Limited Modular Transmitter Equipment Under Testing (‘EUT’) satisfy the requirement for Single Modular Approval Single Limited Modular Approval as detailed in FCC Public Notice DA00-1407. FCC Requirement of Modular Approval 1. The modular transmitter must have its own RF shielding. YES NO 2. The modular transmitter must have buffered modulation/data inputs. YES NO 3. The modular transmitter must have its own power supply regulation. YES NO The modular transmitter must comply with the antenna requirements of section 4. YES NO 15.203 and 15.204(c). 5. The modular transmitter must be tested in a stand-alone configuration. YES NO 6. The modular transmitter must be labeled with its own FCC ID number. YES NO The modular transmitter must comply with any specific rule or operating 7. requirements applicable to the transmitter and the manufacture must provide YES NO adequate instruction along with the module to explain any such requirements. The modular transmitter must comply with any applicable RF exposure 8. YES NO requirements. Note :  Limited modular approval may be granted If EUT does not meet all of the requirement shown above  Limited modular approval may be granted in case that the applicant can demonstrate to retain control over the final installation of the device such that compliance of the end product is assured. In that case, an operating condition on the limited modular approval for the module shall state that the module is only designated for the end product manufactured by a specific manufacturer  When limited modular approval is sought, the application for equipment certification shall state how control of the end product into which the module will be installed and maintained such that full compliance of the end product is always ensured.  It shall be provided that clear and specific instructions describing the conditions limitations and procedures for third-parties to use and/or integrate the module into a host device  For non-Software Defined Radio transmitter modules where software is used to ensure compliance of the device, it shall be provided that the technical description of how such control is implemented to ensure to prevent the third party from modifying (see KDB 594280).  Compliance of a module in its final configuration is the responsibility of the applicant. A host device will not be considered certified if the instructions regarding antenna configuration provided in the original description, of one or more separately certified modules it contains, were not followed. Example: A separately certified low-power transceiver module using Bluetooth technology which is housed in a desktop computer, laptop or peripheral does not require the overall system to be recertified, if the desktop computer, laptop or peripheral, as a stand-alone unit, complies with all applicable technical standards. ___________________________________ Kyungbok Kim / Senior engineering manager kbkim@telit.com +82-10-8530-0622 Via Stazione di Prosecco 5/B Trieste 34010, Italy HACS-F007 Modular Approval Declaration Letter Rev : 2.1


Document Created: 2014-04-04 09:56:00
Document Modified: 2014-04-04 09:56:00
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC