Antenna Spec.

FCC ID: RBWESY10I1B

Cover Letter(s)

Download: PDF
FCCID_3622023

WA-P-LB-03-077 Specification 1. Explanation of part number : WA _ P _ LB _ 03 _ 077 (1) (2) (3) (4) (5) (1) Product Type：Wireless Antenna (2) Material: PCB (3) Frequency : WIFI (2.4GHz-2.5GHZ,5.1GHz~5.8GHz) (4) Coaxial Cable Type : 03 (5) Suffix :077 2. Electrical Specification : Those specifications were specially defined for WIFI model, and all characteristics were measured under the model’s handset testing . 2-1. Frequency Band: Frequency Band GHz WIFI 2.4-2.5GHz,5.1-5.8GHz 2-2. Impedance 50 ohm nominal 1UNLESS OTHER SPECIFIED TOLERANCES ON： X＝± X.X＝± X.XX＝± 佳邦科技股份有限公司 ANGLES＝± HOLEDIA＝± INPAQ TECHNOLOGY CO., LTD. SCALE： UNIT：mm THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF INPAQ TECHNOLOGY CO.,LTD.AND SHALL NOT BE REPRODUCED OR USED DRAWN BY:余骏 CHECKED BY: 李志强 AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DESIGNED BY：张冲 APPROVED BY：胡志清 DEVICES WITHOUT PERMISSION DOCUMENT PAGE REV. TITLE：WA-P-LB-03-077 Specification ENS000102310 NO. P1 PAGE 1 OF 5

2-3. VSWR 2-3-1.Measurement frequency points and VSWR value Frequency（MHz） 2400 2500 5100 5800 VSWR 2.04 2.02 1.98 1.76 2-3-2. VSWR Frequency 5800 2400 2500 5100 Band(MHz) 2-3-3. Typical ≤3.5 ≤3.5 ≤3.5 ≤3.5 Value: 2-3-4 1. A 50Ωcoaxial cable is connected to the PCB. Then this cable is connected Measuring to a network analyzer to measure the VSWR. Method 2. Keeping this jig away from metal at least 20 cm 2-3-5 Picture 2UNLESS OTHER SPECIFIED TOLERANCES ON： X＝± X.X＝± X.XX＝± 佳邦科技股份有限公司 ANGLES＝± HOLEDIA＝± INPAQ TECHNOLOGY CO., LTD. SCALE： UNIT：mm THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF INPAQ TECHNOLOGY CO.,LTD.AND SHALL NOT BE REPRODUCED OR USED DRAWN BY:余骏 CHECKED BY: 李志强 AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DESIGNED BY：张冲 APPROVED BY：胡志清 DEVICES WITHOUT PERMISSION DOCUMENT PAGE REV. TITLE：WA-P-LB-03-077 Specification ENS000102310 NO. P1 PAGE 2 OF 5

2-4. Efficiency and Gain n 量测仪器: 微波暗室, 网络分析仪, 标准天线. n 微波暗室说明: 这是本公司设置在深圳的微波暗室，本微波暗室是属于一套远场量测系统,暗室的大小为 2.6 米 x1.6 米 x1.6 米 ，静区尺寸(Quiet zone)大小为 15 厘米 x15 厘米 x15 厘米。 图. 1. 微波暗室内部仪器设置 图. 1 为微波暗室内的仪器设置及网络分析仪的联接图，发射天线(本暗室所使用发射天线的型号为 TRC LPA0860 800MHZ-6GHZ)到待测天线(AUT)的距离为 1.35 米，待测天线放置在旋转平台上,藉由控制 转台旋转的角度可对待测天线做概略性及较为准确的量测。 将待测天线放置于旋转台上,并测得其各个平面(ZY 平面及 ZX 平面)的 360 度场强数据。再将待测天 线换置成标准偶极天线(本暗室所使用的标准偶极天线型号为 TRC AD series dipole antenna 800MHz~2500MHz)将其 360 度的场强数据测出，以作换算增益标准值，经由式 1 的换算即可获得待测天 线的增益值及方向图。 3UNLESS OTHER SPECIFIED TOLERANCES ON： X＝± X.X＝± X.XX＝± 佳邦科技股份有限公司 ANGLES＝± HOLEDIA＝± INPAQ TECHNOLOGY CO., LTD. SCALE： UNIT：mm THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF INPAQ TECHNOLOGY CO.,LTD.AND SHALL NOT BE REPRODUCED OR USED DRAWN BY:余骏 CHECKED BY: 李志强 AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DESIGNED BY：张冲 APPROVED BY：胡志清 DEVICES WITHOUT PERMISSION DOCUMENT PAGE REV. TITLE：WA-P-LB-03-077 Specification ENS000102310 NO. P1 PAGE 3 OF 5

2-4-1 Efficiency and Gain 2-4-1-1 电气测试要求 Frequency (MHz) Efficiency (%) Peak Gain (dBi) 2400 >30 >1.5 2450 >30 >1.5 2500 >30 >1.5 5100 >30 >1.5 5400 >30 >1.5 5800 >30 >1.5 2-4-1-2 电气测试数据 Frequency (MHz) Efficiency (%) Peak Gain (dBi) 2400 49.65 2.84 2450 56.71 2.92 2500 52.17 2.86 5100 46.93 2.67 5400 48.31 2.70 5800 43.64 2.64 3. Mechanical Specification: 3-1. Mechanical Configuration (Unit: mm) （* dimension is important dimension) The appearance of the antenna is according to drawing Figure 3-1-1 4UNLESS OTHER SPECIFIED TOLERANCES ON： X＝± X.X＝± X.XX＝± 佳邦科技股份有限公司 ANGLES＝± HOLEDIA＝± INPAQ TECHNOLOGY CO., LTD. SCALE： UNIT：mm THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF INPAQ TECHNOLOGY CO.,LTD.AND SHALL NOT BE REPRODUCED OR USED DRAWN BY:余骏 CHECKED BY: 李志强 AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DESIGNED BY：张冲 APPROVED BY：胡志清 DEVICES WITHOUT PERMISSION DOCUMENT PAGE REV. TITLE：WA-P-LB-03-077 Specification ENS000102310 NO. P1 PAGE 4 OF 5

3-2. Cable Length: 接头端 Connector：I-PEX MHF(20278-112R-13)；Cable：RF Cable 1.13（GRAY） 线长(含接头) H：50±3mm 5UNLESS OTHER SPECIFIED TOLERANCES ON： X＝± X.X＝± X.XX＝± 佳邦科技股份有限公司 ANGLES＝± HOLEDIA＝± INPAQ TECHNOLOGY CO., LTD. SCALE： UNIT：mm THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF INPAQ TECHNOLOGY CO.,LTD.AND SHALL NOT BE REPRODUCED OR USED DRAWN BY:余骏 CHECKED BY: 李志强 AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DESIGNED BY：张冲 APPROVED BY：胡志清 DEVICES WITHOUT PERMISSION DOCUMENT PAGE REV. TITLE：WA-P-LB-03-077 Specification ENS000102310 NO. P1 PAGE 5 OF 5


Document Created: 2017-08-17 09:09:39
Document Modified: 2017-08-17 09:09:39
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC