RF Exposure Info

FCC ID: RA8-BH002

RF Exposure Info

Download: PDF
FCCID_1138174

                                               SGS-CSTC Standards Technical Services Co., Ltd.

No. 1 Workshop, M-10, Middle Section, Science & Technology Park,
District Shenzhen, China 518057
Telephone:      +86 (0) 755 2601 2053
Fax:            +86 (0) 755 2671 0594
Email:          sgs_internet_operations@sgs.com
                                                                                                             Page: 1 of 1
                                                                                                             FCC ID: RA8-BH002


                                    RF Exposure Statement
1.      RF Exposure Compliance Requirement
1.1 Standard requirement
                15.247(b)(4) requirement:
                (4) The conducted output power limit specified in paragraph (b) of this section is based
                on the use of antennas with directional gains that do not exceed 6 dBi. Except as shown in
                paragraph (c) of this section. if transmitting antennas of directional gain greater than 6 dBi are
                used. the conducted output power from the intentional radiator shall be reduced below the stated
                values in paragraphs (b)(1). (b)(2). and (b)(3) of this section. as appropriate. by the amount in dB
                that the directional gain of the antenna exceeds 6 dBi.


1.2 EUT RF Exposure
                The Max Conducted Peak Output Power is 4.99dBm(3.155mW) in lowest channel (2.402GHz);
                The best case gain of the antenna is 0dBi.
                0dB logarithmic terms convert to numeric result is nearly 1.0
                According to the formula. calculate the EIRP test result:

                EIRP= P x G = 3.155 mW x 1.0 = 3.155mW ①
                SAR requirement:
                S= 60 / f(GHz) = 60/2.402 = 24.98 mW ② ;
                ① < ②.
                So the SAR report is not required.




“This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at
www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at
www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any
holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within
the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a
transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full,
without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is
unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to
the sample(s) tested and such sample(s) are retained for 90 days only.”



Document Created: 2009-07-14 15:16:11
Document Modified: 2009-07-14 15:16:11

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC