RF EXPOSURE

FCC ID: R7PTOP04

RF Exposure Info

Download: PDF
FCCID_611784

FCC Part 15 Subpart C Transmitter Certification Frequency Hopping Spread Spectrum Transmitter FCC ID: R7PTOP04 FCC Rule Part: 15.247 ACS Report Number: 05-0327-15C Manufacturer: Cellnet Technology, Inc. Model: Take Out Point (TOP) RF Exposure Information 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Model: Take Out Point (TOP) Advanced Compliance Solutions FCC ID: R7PTOP04 General Information: Applicant: Cellnet ACS Project: 05-0327 FCC ID: R7PTOP04 Device Category: Fixed Environment: General Population/Uncontrolled Exposure Technical Information: Antenna Type: Whip Antenna Gain: 5dBi Transmitter Conducted Power: 29.75dBm Maximum System EIRP: 34.75dBm Operating Configuration: Fixed mounted Exposure Conditions: Greater than 20 centimeters Antenna Separation (Co-location): Greater than 20 centimeters MPE Calculation The Power Density (mW/cm2) is calculated as follows: PG S= 4πR 2 Where: S = power density (in appropriate units, e.g. mW/cm2) P = power input to the antenna (in appropriate units, e.g., mW) G = power gain of the antenna in the direction of interest relative to an isotropic radiator R = distance to the center of radiation of the antenna (appropriate units, e.g., cm) MPE Calculator for Mobile Equipment Limits for General Population/Uncontrolled Exposure* Transmit Radio Power Radio Antenna Antenna Power Freq. Power Density Power Gain Gain Distance Density (MHz) (dBm) Limit (mW) (dBi) (mW eq.) (cm) (mW/cm^2) (mW/Cm2) 903 29.75 0.60 944.06 5.00 3.162 20 0.594 Installation Guidelines The installation manual contains the following text advising how to install the equipment to maintain compliance with the FCC RF exposure requirements: “RF Exposure (Intentional Radiators Only) In accordance with FCC requirements of human exposure to radiofrequency fields, the radiating element shall be installed such that a minimum separation distance of 20cm is maintained from the general population.” Conclusion This device complies with the MPE requirements by providing adequate separation between the device, any radiating structure and the general population. ACS Report: 05-0327-15C Page 2


Document Created: 2005-10-27 14:26:47
Document Modified: 2005-10-27 14:26:47
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC