MPE

FCC ID: QZEWLA532E

RF Exposure Info

Download: PDF
FCCID_1999765

JNIP22-1 Maximum Permissible Exposure 5250 – 5350 MHz and 5470 – 5725 MHz Bands FCC, Part 15 §1.1310 Industry Canada RSS-Gen §5.6 Calculations for Maximum Permissible Exposure Levels Power Density = Pd (mW/cm2) = EIRP/(4πd2) EIRP = P * G P = Peak output power (mW) G = Antenna numeric gain (numeric) d = Separation distance (cm) Numeric Gain = 10 ^ (G (dBi)/10) Because the EUT belongs to the General Population/Uncontrolled Exposure the limit of power density is 1.0 mW/cm2 The calculations in the table below use highest gain antennas for the client EUT. Where the antenna gain exceeds 6dBi the transmitter power is reduced to meet the EIRP requirements. These calculations represent worst case in terms of the exposure levels. Peak Peak Calculated Minimum Numeric Freq. Band Antenna Output Output Safe Distance Separation Gain (MHz) Gain (dBi) Power Power @ 1mW/cm2 Distance (numeric) (dBm) (mW) Limit(cm) (cm) 5250 - 5350 10.7 11.75 19.3 85.1 8.92 20 5470 - 5725 10.7 11.75 19.3 85.1 8.92 20 Note: for mobile or fixed location transmitters the minimum separation distance is 20cm, even if calculations indicate the MPE distance to be less. Specification Maximum Permissible Exposure Limits FCC §1.1310 Limit = 1mW / cm2 from 1.310 Table 1 RSS-Gen §5.6 Category I and Category II equipment shall comply with the applicable requirements of RSS-102. Laboratory Measurement Uncertainty for Power Measurements Measurement uncertainty ±1.33 dB


Document Created: 2013-06-10 14:47:39
Document Modified: 2013-06-10 14:47:39
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC