Modular Request Letter

FCC ID: QOQWFM200

Cover Letter(s)

Download: PDF
FCCID_4469071

SILICON LABS
                                       Modular Request Letter
                                                                    SGS North America Inc.
                                                                    620 Old Peachtree Road, SUITE 100
                                                                    Suwanee, Georgia, United States


       Attn:    To Whom it May Concern / Application Examiner / Review Engineer / Officer in Charge
       Re:      Request for FCC module certification, FCC ID: QOQWFM200


       Dear Madam or Sir,

       We, Silicon Laboratories Finland Oy, a corporation validly organized and existing under the laws of
       Finland, having its principal place of business at Alberga Business Park, Bertel Jungin aukio 3,
       02600 Espoo, Finland,

       hereby request a Full Modular certification for the FCC ID referenced above.

       The device meets the requirements indicated below as outlined in the FCC KDB 996369 DOl
       Module Equip Auth Guide vOl r04
         • The device has buffered modulation/data inputs to ensure that the device will comply with Part
            15 requirements with any type of input signal;
         • The device has power supply regulation on the module, except for the last stage PA; the
            device is proven to be compliant between the mm and max supply voltage being instructed in
            the integration manual, and the firmware prevents operation when the supply voltage is
            outside the indicated range; a pre-approval for this case exists, KDB Tracking Number 935357
         • The device has a permanently attached antenna, or contain a unique antenna connector, and
            be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b),
            15.204(c), 15.212(a), 2.929(b);
         • The device has demonstrated compliance in a stand-alone configuration;
         • The device will not be labeled with a permanently affixed FCC ID label due to the small size;
            the ID is printed in the packaging label, and the integration manual mentions the ID and the
            need by the integrator to refer to the ID in the end-product labelling.
         • The device does comply with all specific rules applicable to the transmitter including all the
            conditions provided in the integration instructions by the grantee;
         • The device does comply with RF exposure requirements.

       Should there be any query regarding this request, please do not hesitate to contact the
       undersigned. Thank you for your attention to this matter.


       Place and date of issue (of thiIetter):
       Espoo, September 25




       Senior Contact: Pasi Rahikkala
       Job Title: Staff Hardware Engineer, loT Wireless Modules
       Email: pasi.rahikkala © silabs.com
Silicon Laboratories Finland Oy
Alberga Business Park
Bertel Jungin aukio 3
Fl-02600 Espoo, Finland
Phone: +358 9 435 5060
www.silabs.com



Document Created: 2019-10-03 04:05:32
Document Modified: 2019-10-03 04:05:32

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC