Modular Appr Letter

FCC ID: QLYRYLR896

Cover Letter(s)

Download: PDF
FCCID_3987740

Applicant/Grantee REYAX TECHNOLOGY CO.,LTD. FCC ID: QLYRYLR89 | I Section 15.212 Modular Transmitters / Request for Modular Approval _| | Request for Limited Modular Approval Requirements Device Conditions Comply (Y/N) Single Modular Approval Requirements The radio elements must have the radio This module has shielding case. frequency circuitry shielded. Physical/discrete and tuning capacitors may be located external to the shield, but must be on the module assembly. The module shall have buffered all modulation and data input(s) are modulation/data input(s) (if such inputs are buffered. The EUT has buffered data provided) to ensure that the module will inputs, it is integrated on the RF chip icomply with the requirements set out in the} lapplicable RSS standard under conditions lof excessive data rates or over—modulation. [The module shall have its own power LoRa system on Chip IC contains supply regulation on the module. This is to multiple dedicated voltage regulators ensure that the module will comply with for transmitter chain including the requirements set out in the applicable modulator, per—power amplifier, and standard regardless of the design of the power amplifier. jpower supplying circuitry in the host device which houses the module. Requirements set out in the applicable standard regardless of the design of the power supplying circuitry in the host device which houses the module. [The module shall comply with the Include spring antenna assy. jprovisions for external power amplifiers and antennas detailed in this standard. The Equipment certification submission shall contain a detailed description of the lconfiguration of all antennas that will be used with the module. he module shall be tested for compliance See Setup Photos |with the applicable standard in a stand— lalone configuration, i.e. the module must inot be inside another device during testing. [The modular transmitter must be See Label Exhibit lequipped with either a permanently affixed label.

[The modular transmitter complies with all Instructions in User Manual ispecific rules or operating requirements ithat ordinarily apply to a complete transmitter and the manufacturer will jprovide adequate instructions along with the module to explain any such requirements. A copy of these instructions is included in this application for equipment authorization: |Address compliance with the Instructions are given in the installation Commission‘s RF exposure limits in manual for compliance to the RF Sections 1.1310 and 2.1093. In addition, exposure requirements. spread spectrum transmitters operating lunder Section 15.247 are required to laddress RF exposure compliance in laccordance with Section 15.247(b)(4). A limited modul: pJ roval may be granted for single or split modular transmitters that do not comply with all of the above requirements, e.g., shielding, minimum signaling amplitude, buffered modulation/data inputs, or power supply regulation, if the manufacturer can demonstrate by alternative means in the application for equipment authorization that the modular transmitter meets all the applicable Part 15 requirements under the operating conditions in which the transmitter will be used. Limited modular approval also may be granted in those instances where compliance with RF exposure rules is demonstrated only for particular product configurations. The applicant for certification must state how control of the end product into which the module will be installed will be maintained such that full compliance of the end product is always ensured. Signature Name/Title: Ritchie Chang/ Manager Company Name: REYAX TECHNOLOGY CO.,LTD. Date: 27 Jul 2018 i\


Document Created: 2019-10-12 07:57:24
Document Modified: 2019-10-12 07:57:24
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC