EHS8 Modular Approval FCC

FCC ID: QIPEHS8

Cover Letter(s)

Download: PDF
FCCID_4197139

to* genial Gemalto M2M GmbH Siemensdamm 50 13629 Berlin. Germany Federal Communication Commission Name Axel Heike Department System Test Certifications Equipment Authorization Division, Application - Processing Branch Phone +493031102-8146 7435 Oakland Mills Road Fax +493031702-8305 Columbia, MD 21048 E-Mail AxeI.Heikegemalto.com USA Your letter of Our reference Date 28 January2019 Modular Approval Statement FCC Certification Number: QIPEHS8 47 CFR 15.212 Modular Transmitters - Request for Modular Approval X Request for Limited Modular Approval Requirements EUT Conditions Comply (YIN) Single Modular Approval Requirements The radio elements of the modular The modular transmitter has its own transmitter must have their own RE shielding. Please refer to shielding. The physical crystal and tuning external photos. Y capacitors may be located external to the shielded radio elements. The modular transmitter must have The module has buffered buffered modulation/data inputs (if such modulation/data inputs to ensure inputs are provided) to ensure that the that the device will comply with Part 2 module will comply with part 15 15 requirements with any type of requirements under conditions of input signal. excessive data rates or over-modulation. . The modular transmitter has its own . The modular transmitter must have its 3 power supply regulation. Please . Y own power supply regulation. refer to PMD9635 in Schematic. The modular transmitter must comply The requirements of antenna with the antenna and transmission connector and spurious emissions system requirements of § 15.203, have been fulfilled. Please refer to 15.204(b) and 15.204(c). The antenna Test Report. either be permanently attached or must employ a “unique” antenna coupler (at all connections between the module and the antenna, including the cable). The “professional installation” provision of § 15.203 is not applicable to modules but www.gemalto.comlm2m Registered Office: Managing Directora: commercial register, Reg. No.: Gemalto M2M GmbH Andreas Hdgele, Sébastien Gallois Amtsgericht Ménchen, HRB 172715 Werinherstr. 81 WEEE-Reg.-Nr. DE 58893809 81541 Munich Germany

gemal [ox can apply to limited modular approvals under paragraph (b) of this section. The modular transmitter must be tested The modular transmitter is tested in in a stand-alone configuration, i.e., the a stand-alone configuration. Please module must not be inside another refer to Setup Photo. device during testing for compliance with part 15 requirements. Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in § 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless 5 Y they will be marketed with the module (see § 15.27(a)). The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available (see § 15.31(i)). The modular transmitter must be The modular transmitter is labelled equipped with either a permanently with its own FCC ID. Labelling affixed label or must be capable of instructions for host devices are electronically displaying its FCC stated in the user manual under identification number. chapter “Compliance with FCC and (A) If using a permanently affixed label, the IC Rules and Regulations” modular transmitter must be labeled with its own FCC identification number, and, if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the 6 module is installed must also display a label Y referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: XYZMODEL 7” or “Contains FCC ID: XYZMODEL7. “Any similar wording that expresses the same meaning may be used. The Grantee may either provide such a label, an example of which must be included in the application for equipment authorization, or, must provide adequate instructions along with the module which explain this www. gem alto. comlm 2m

[ox gemal requirement. In the latter case, a copy of these instructions must be included in the application for equipment authorization. (B) If the modular transmitter uses an electronic display of the FCC identification number, the information must be readily accessible and visible on the modular transmitter or on the device in which it is installed. If the module is installed inside another device, then the outside of the device into which the module is installed must display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains FCC certified transmitter module(s). “Any similar wording that expresses the same meaning may be used. The user manual must include instructions on how to access the electronic display. A copy of these instructions must be included in the application for equipment authorization. The modular transmitter must comply The modular transmitter complies with any specific rules or operating with any specific rules or operating requirements that ordinarily apply to a requirements. Instructions are complete transmitter and the provided in the user manual. 7 manufacturer must provide adequate Y instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. . The modular transmitter complies The modular transmitter must comply . . with RF exposure requirements. 8 with any applicable RF exposure . Y . . . . . . Please refer to MPE calculation for requirements in its final configuration. . the exposure information. If you have any questions, please feel free to contact us at the address shown above. Sincerel/,; Axel Heike Certification Managr / Lars Wehmeier Head of System Test www.gemalto.comlm2m


Document Created: 2019-01-30 13:39:48
Document Modified: 2019-01-30 13:39:48
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC