Test Report II

FCC ID: Q9SAWR-D6500

Test Report

Download: PDF
FCCID_4321771

GC Report No.: AGC02415190302FE10 Page 81 of 101 Conducted Spurious Emission (worst) @ 400.025MHz MHz With 12.5 KHz Channel Separation—5W 30MHz—1GHz 4 Agilent T |Freqi/Channel Center Freq 515.000000 MHz Start Freq 30.0000000 MHz Stop Freq 1.909000000 CHz CF Step 97.0000000 MHz Auto Man Freq Offset 0.00000000 Hz —35.19 dBm Signal Track On Off Conduct Spurious Emission (worst) @ 400.025MHz MHz With 12.5 KHz Channel Separation—5W 1GHz—12.75GHz x Agilent L Freq/Channel ce es i R Center Freq «Atten 10 dB ts 557590000 CHiz Start Freq 1.90000000 CHz Stop Freq 12.7500000 CHz CF Step 1.175909000 GHz Auto Man Freq Offset *VBHW 3 0.00000000 Hz Signal Track On Off Copyright 2000—2005 Agilent Technologies Attestation of Global Compliance(Shenzhen)Co.,Ltd. Add: 2/F., Building 2, No.1—4, Chaxi Sanwei Technial Industrial Park, Gushu, Xixiang, Bac‘an District, Shenzhen, Guangdong, China Tel: +86—755 2523 4088 E—mail: agc@ageo—cert.com Service Hotline:400 089 2118

Report No.: AGC02415190302FE10 Page 82 of 101 Conducted Spurious Emission (worst) @ 453.225MHz With 12.5 KHz Channel Separation-5W 30MHz-1GHz Conduct Spurious Emission (worst) @ 453.225MHz With 12.5 KHz Channel Separation-5W 1GHz-12.75GHz

Report No.: AGC02415190302FE10 Page 83 of 101 Conducted Spurious Emission (worst) @ 454.025MHz With 12.5 KHz Channel Separation-5W 30MHz-1GHz Conduct Spurious Emission (worst) @ 454.025MHz With 12.5 KHz Channel Separation-5W 1GHz-12.75GHz

Report No.: AGC02415190302FE10 Page 84 of 101 Conducted Spurious Emission (worst) @ 479.975MHz With 12.5 KHz Channel Separation-5W 30MHz-1GHz Conduct Spurious Emission (worst) @ 479.975MHz With 12.5 KHz Channel Separation-5W 1GHz-12.75GHz NOTE: ALL THE TEST FREQUENCIES WAS TESTED, BUT ONLY THE WORST DATA BE RECORDED IN THIS PART.

® A\GC Report No.: AGC02415190302FE10 Page 85 of 101 11.RANSMITTER FREQUENCY BEHAVIOR 11.1PROVISIONS APPLICABLE FCC §90.214 All equipment ie i q Maximum frequency Time intervals t difference 150 to 174 MHz 421 to 512 & MHz Transient Frequency Behavior for Equipment Designed to Operate on 25 kHz Channels EJ $ Lo nlnl n n en n n nn en nn nc nennennnnnmnennnennennen mm | + 25.0 KHZ 5.0 ms 10.0 ms PB ons es en emerre en rr en e rrrrerrerrerrerrereerrernarner en en en se reernsr esn ene ce e e e | t 12.5 KHZ 20.0 ms 25.0 ms Pg $ uonl ns n n enc enc nrnnrncrncrnsresrerrerrereerrermesrnsenrrnrrenecrmermeesneceenecee ce t 25.0 KHZ 5.0 ms 10.0 ms Transient Frequency Behavior for Equipment Designed to Operate on 12.5 kHz Channels Ap B uen snn enc enc nr n r esnc recresrenrerrerrerrerrerrerrerrerenreerecreereereneneenee e | t 12.5 KHZ 5.0 ms 10.0 ms BB onl onl onl onl en cnnnnnnnennennnnnnnrrnrrnneeneeneesesnnennrene se ll. t 6.25 KHZ 20.0 ms 25.0 ms PE $ slsn en nc nv en n recrecrnsrenrerrerrerrerrerrerrerrerenrrerecrmernermenenne enc en e | t 12.5 KHZ 5.0 ms 10.0 ms Transient Frequency Behavior for Equipment Designed to Operate on 6.25 kHKz Channels J 3 uonl enc nn en nrn en nc ren en rrnrrerenrrnneerrnsrereereerecreresesneeeeee e | t 625 KHZ 5.0 ms 10.0 ms N unsc en en rnerrerenrrnrrereerrerrarrerrerrereereerrarnereereereerecreer es eerene ce e | t 3125 KHZ 20.0 ms 25.0 ms oi 2 2 12i 5.0 ms 10.0 ms 1t.. is the instant when a 1 kHz test signal is completely suppressed, including any capture time due to phasing. t; is the time period immediately following t;,. t is the time period immediately following ti. t; is the time period from the instant when the transmitter is turned off until to#z. tog is the instant when the 1 kHz test signal starts to rise. 2 Quring the time from the end of t; to the beginning of t;, the frequency difference must not exceed the limits specified in §90.213. 3 Difference between the actual transmitter frequency and the assi?‘ned transmitter frequenc * If the transmitter carrier output power rating is 6 watts or less, the frequency difference d{iring this time period may exceed the maximum frequency difference for this time period. 11.2 TEST METHOD TIMEIA—603 2.2.19.3 Attestation of Global Compliance(Shenzhen)Co.,Ltd. Add: 2/F., Building 2, No.1—4, Chaxi Sanwei Technial Industrial Park, Gushu, Xixiang, Bac‘an District, Shenzhen, Guangdong, China Tel: +86—755 2523 4088 E—mail: agc@ageo—cert.com Service Hotline:400 089 2118

Report No.: AGC02415190302FE10 Page 86 of 101 11.3 DESCRIBE LIMIT LINE OF RANSMITTER FREQUENCY BEHAVIOR ton: The switch-on instant ton of a transmitter is defined by the condition when the output power, measured at the antenna terminal, exceeds 0,1 % of the full output power (-30 dBc). t1: period of time starting at ton and finishing according to above 11.1 t2: period of time starting at the end of t1 and finishing according to above 11.1 toff: switch-off instant defined by the condition when the output power falls below 0,1 % of the full output power (-30 dBc). t3: period of time that finishing at toff and starting according to above 11.1

Report No.: AGC02415190302FE10 Page 87 of 101 11.4 MEASURE RESULT UHF: Transmitter Frequency Behavior @ 12.5 KHz Channel Separation--Off to On Transmitter Frequency Behavior @ 12.5 KHz Channel Separation--On to Off

Report No.: AGC02415190302FE10 Page 88 of 101 12. AUDIO LOW PASS FILTER RESPONSE 12.1.TEST LIMITS 2.1047(a): Voice modulated communication equipment. A curve or equivalent data showing the frequency response of the audio modulating circuit over a range of 100 to 5000 Hz shall be submitted. For equipment required to have an audio low-pass filter, a curve showing the frequency response of the filter or of all circuitry installed between the modulation limiter and the modulated stage shall be submitted. 90.242(b)(8): Recommended audio filter attenuation characteristics are given below: 12.2. METHOD OF MEASUREMENTS The rated audio input signal was applied to the input of the audio low-pass filter (or of all modulation stages) using an audio oscillator, this input signal level and its corresponding output signal were then measured and recorded using the FFT Digital Spectrum Analyzer. Tests were repeated at different audio signal frequencies from 0 to 50 KHz.

Report No.: AGC02415190302FE10 Page 89 of 101 12.3.MEASURE RESULT Analog: 12.5 KHZ CHANNEL SPACING, F3E, FREQUENCY OF ALL MODULATION STATES (TEST RESULT FOR UHF)-5W Audio Frequency (kHz) Response Attenuation (dB) Limit (dB) 1 0 / 3 -2.33 0.00 4 -6.58 -5.00 5 -10.42 -8.87 6 -13.59 -12.04 7 -16.27 -14.72 8 -18.59 -17.04 9 -20.63 -19.08 10 -22.47 -20.92 15 -29.55 -28.00 20 -29.55 -28.00 30 -29.55 -28.00 50 -29.55 -28.00 70 -29.55 -28.00

Report No.: AGC02415190302FE10 Page 90 of 101 APPENDIX I: PHOTOGRAPHS OF SETUP RADIATED EMISSION TEST SETUP

Report No : AGCO02415190302FE10 Page 91 of 101 CONDUCTED TEST SETUP Attestation of Global Compliance(Shenzhen)Co.,Ltd. Add: 2/F., Building 2, No.1—4, Chaxi Sanwei Technial Industrial Park, Gushu, Xixiang, Bao‘an District, Shenzhen, Guangdong, China Tel: +86—755 2523 4088 E—mail: agc@ageo—cert.com Service Hotline:400 089 2118

Report No.: AGC02415190302FE10 Page 92 of 101 APPENDIX II PHOTOGRAPHS OF EUT TOTAL VIEW OF EUT Antenna TOP VIEW OF EUT

Report No.: AGC02415190302FE10 Page 93 of 101 BOTTOM VIEW OF EUT FRONT VIEW OF EUT

Report No.: AGC02415190302FE10 Page 94 of 101 BACK VIEW OF EUT LEFT VIEW OF EUT

Report No.: AGC02415190302FE10 Page 95 of 101 RIGHT VIEW OF EUT OPEN VIEW OF EUT-1

Report No.: AGC02415190302FE10 Page 96 of 101 OPEN VIEW OF EUT-2 OPEN VIEW OF EUT-3

Report No.: AGC02415190302FE10 Page 97 of 101 OPEN VIEW OF EUT-4 INTERNAL VIEW OF EUT - 1

Report No.: AGC02415190302FE10 Page 98 of 101 INTERNAL VIEW OF EUT - 2 INTERNAL VIEW OF EUT - 3

Report No.: AGC02415190302FE10 Page 99 of 101 INTERNAL VIEW OF EUT - 3 INTERNAL VIEW OF EUT - 4

Report No.: AGC02415190302FE10 Page 100 of 101 INTERNAL VIEW OF EUT - 5 INTERNAL VIEW OF EUT - 6

Report No.: AGC02415190302FE10 Page 101 of 101 INTERNAL VIEW OF EUT - 7 ----END OF REPORT----


Document Created: 2019-06-18 15:04:02
Document Modified: 2019-06-18 15:04:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC