RFx

FCC ID: Q9DAPIN0114115

RF Exposure Info

Download: PDF
FCCID_2037151

ARUB148 Maximum Permissible Exposure FCC, Part 15 §1.1310 Industry Canada RSS-Gen §5.6 Calculations for Maximum Permissible Exposure Levels Power Density = Pd (mW/cm2) = EIRP/(4πd2) EIRP = P * G P = Peak output power (mW) G = Antenna numeric gain (numeric) d = Separation distance (cm) Numeric Gain = 10 ^ (G (dBi)/10) Because the EUT belongs to the General Population/Uncontrolled Exposure the limit of power density is 1.0 mW/cm2 The calculations in the table below use highest gain antennas for the client EUT. Where the antenna gain exceeds 6dBi the transmitter power is reduced where necessary to meet the EIRP requirements. These calculations represent worst case in terms of the exposure levels. Peak Peak Calculated Minimum Numeric Freq. Band Antenna Output Output Safe Distance Separation Gain (MHz) Gain (dBi) Power Power @ 1mW/cm2 Distance (numeric) (dBm) (mW) Limit(cm) (cm) 2400 – 2483.5 7.5 5.62 27.61 577 16.1 20 5725 - 5850 7.5 5.62 27.06 509 15.1 20 5150 - 5250 7.5 5.62 15.5 35.5 4.0 20 Assessment for simultaneous operation in 2.4 GHz and 5 GHz bands The Aruba APIN0114, APIN0115 has two identical radio modules. Each module is dual band, but each one is dedicated to operate ONLY in 1 band (2.4 GHz or 5 GHz). The following assessment is based on simultaneous operation in the 2.4 GHz and 5 GHz bands. Peak Peak Calculated Minimum Numeric Freq. Band Antenna Output Output Safe Distance Separation Gain (MHz) Gain (dBi) Power Power @ 1mW/cm2 Distance (numeric) (dBm) (mW) Limit(cm) (cm) 2400 – 2483.5 7.5 5.62 27.61 577 16.1 20 5725 - 5850 7.5 5.62 27.06 509 15.1 20 Combined 7.5 5.62 30.35 1086 22.0 22.0 Total

Note: for mobile or fixed location transmitters the minimum separation distance is 20cm, even if calculations indicate the MPE distance to be less. Specification Maximum Permissible Exposure Limits FCC §1.1310 Limit = 1mW / cm2 from 1.310 Table 1 RSS-Gen §5.6 Category I and Category II equipment shall comply with the applicable requirements of RSS-102. Laboratory Measurement Uncertainty for Power Measurements Measurement uncertainty ±1.33 dB


Document Created: 2013-08-07 13:49:48
Document Modified: 2013-08-07 13:49:48
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC