FCC ID Label

FCC ID: Q2331308

ID Label/Location Info

Download: PDF

FCCID_1278330

Infineon Technologies FCC ID: Q2331308, IC: 6850A-31308

8 EXHIBIT A – FCC & IC Labeling Requirement
8.1 FCC ID Label Requirements
As per FCC §2.925,

(a) Each equipment covered in an application for equipment authorization shall bear a nameplate or label listing
the following:

(1) FCC Identifier consisting of the two elements in the exact order specified in §2.926. The FCC Identifier shall
be preceded by the term FCC ID in capital letters on a single line, and shall be of a type size large enough to be
legible without the aid of magnification.

Example: FCC ID XXX123. XXX—Grantee Code 123—Equipment Product Code

As per FCC §15.19,

(a) In addition to the requirements in part 2 of this chapter, a device subject to certification, or verification shall be labeled
as follows:

(3) All other devices shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.

(4) Where a device is constructed in two or more sections connected by wires and marketed together, the statement
specified above is required to be affixed only to the main control unit. If the EUT is integrated within another device then a
label affixed to the host shall also state, “Contains FCC ID: XXXXXX”

(5) When the device is so small or for such use that it is not practicable to place the statement specified under paragraph (a)
of this section on it, the information required by this paragraph shall be placed in a prominent location in the instruction
manual or pamphlet supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
However, the FCC identifier or the unique identifier, as appropriate, must be displayed on the device.

8.2 IC Label Requirements
As per IC RSS-Gen §5, the certification number shall appear as follows:

IC: XXXXXX-YYYYYYYY

Where:
• "XXXXXX-YYYYYYYY" is the certification number
• "XXXXXX" is the Certificate Holder Number (CHN), made of at most 6 alphanumeric characters (A-Z, 0-9),
assigned by Industry Canada; and
• "YYYYYYYY" is the Unique Product Number (UPN), made of at most 11 alphanumeric characters (A-Z, 0-9)
assigned by the applicant.
• Note 1: The term "IC" before the equipment certification number only signifies that the Industry Canada technical
specifications were met.
• Note 2: Note 1 shall be conspicuously placed in the equipment user manual.
• Note 3: Permitted alphanumeric characters used in the CHN and UPN are limited to capital letters (A-Z) and digits
(0-9). Other characters, such as "#", "/" or "-", shall not be used.

Report Number: R1003181-247 Page 24 of 32 FCC Part15.247 & IC RSS-210 Test Report

Document Created: 2010-05-07 13:53:07
Document Modified: 2010-05-07 13:53:07

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC