User Manual (statement)

FCC ID: PY317400405

Users Manual

Download: PDF
FCCID_3771580

       Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.


This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:

-    Reorient or relocate the receiving antenna.
-    Increase the separation between the equipment and receiver.
-   Connect the equipment into an outlet on a circuit different from that
    to which the receiver is connected.
-    Consult the dealer or an experienced radio/TV technician for help.


FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.

For operation
      within 5.15 ~ 5.25GHz
                          / 5.47
                                        ~5.725GHz
                                               frequency
                                                                 range,
                                                                         it
                                                                              is restricted
                                                                                   toindoor
                                                                                                     
   !     "  #$% *    +39  "    ;<<  = 
environment. The band from 5600-5650MHz will be disabled by the software during the
manufacturing and cannot be changed by the end user. This device meets all the other requirements
specified in Part 15E, Section 15.407 of the FCC Rules.


Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 28cm
between the radiator & your body.



Note: The country code selection is for non-US model only and is not available to all US model. Per
FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.



Document Created: 2018-03-01 14:04:00
Document Modified: 2018-03-01 14:04:00

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC