Manual

FCC ID: PRDPRINTER001

Users Manual

Download: PDF
FCCID_938763

User’s Manual Wireless Presenter with Laser Pointer Page 

Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Certification This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. Page 

• Consult the dealer or an experienced radio/TV technician for help. Notice: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Extension cables are not recommended, if used, they must be shielded in order to comply with the emission limits. IC Certification The term “IC” before the certification/registration number only signifies that the Industry Canada technical specifications were met. Declaration of conformity Hereby, SMK-LINK Electronics Corporation, declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. All trademarks and registered trademarks mentioned in this document are the property of their respective owners. Features and specifications are subject to change without notice. © 2008 SMK-LINK Electronics, Inc. Page 

System Requirements Hardware: 1 available USB port Operating System: Windows 2000, XP or Vista Macintosh OS X or above (F5 SlideShow and Alt-Tab Application Switch not supported) Package Contents • Wireless 2.4 GHz presenter • Micro USB receiver dongle (stored inside presenter) • 2 x AAA batteries • User’s manual • Carrying case Installing the Rechargeable Batteries (Supplied) Insert batteries to the correct Sliding the battery cover off polarities Page 

• Open the battery compartment by pressing down the cover latch and sliding the door off the presenter. • Insert the two supplied AAA batteries (included in the package) to the battery slots. Make sure the positive (+) and negative (-) ends of the batteries match the polarity markings inside the battery compartment. • Close the battery cover back into position. Connecting the Presenter to the Computer • Retrieve the micro USB receiver dongle from the built-in storage located at the top-end of the presenter. USB Receiver Top View of the Presenter Page 

• Connect the micro USB receiver dongle to an available USB port on your computer. Wait for the computer to go through its default process of recognizing the new hardware and installing the built-in native driver. You don’t need to do anything while your computer is going through the installation of a new device. • Power on the presenter by sliding the on/off switch to ON position. On/off Switch Power switch on the presenter Page 

• The radio frequency (RF) codes are factory preset for your convenience; the presenter should be functional at this point. • If for any reason the presenter does not function correctly, i.e. the presentation slides do not advance to the next page, there may be other wireless devices in the vicinity operating in the same radio frequency channel. The presenter can easily be reset to another channel by pressing once on the USB receiver dongle’s connect button while it’s plugged in to the computer’s USB port, followed by pressing once on the connect button located at the bottom of the presenter. This will switch the presenter and the receiver to a different channel to avoid interference. This step can be repeated when needed. Page 

Connect Button (1) Press the connect button on the receiver (2) Press the connect button on the presenter Using the Presenter Laser Beam Dongle Storage On/off Scroller Laser Pointer Application Switch Previous Page Next Page Dark Screen Slideshow/Esc Page 

• F5/Esc Slideshow toggle key starts a slideshow (F5) and exits from a slideshow (Esc). Note: in PowerPoint slideshow starts with page 1 when resumed in the middle of a presentation. • Next Page key to advance to the next slide. • Previous Page key to return to the previous slide. • Application Switch (Alt-Tab) key displays all the open windows and switches to the desired window by pausing over the selected window icon for 3 seconds. • Dark Screen toggle key blackens the screen and resumes the presentation. • Laser Pointer key triggers the laser beam. The laser beam emits for the duration that you press the key. Page 

• Scroller on the side allows the presentation of a long document such as an Excel file. Scrolling one notch up or down advances one line at a time. To advance in rapid mode press up or down on the scroller for more than 1 second at a time. In PowerPoint the scroller serves as an alternative key for Next Page and Previous Page. Operating Tips & Trouble Shooting • Make sure the presenter is turned on by checking the on/off switch located at the side of the presenter before using it. • Conserve the battery power by switching the on/off switch to “OFF” position while traveling. If you will not use the presenter for a long period of time remove the batteries from the battery compartment. • When the laser beam becomes dim it may be due to low battery power. Replace with 2 fresh batteries to ensure continuous presentation without power disruption. Page 10

• The presenter stays connected to your computer even when it’s turned off. If for any reason the connection to the system is lost or interference is detected (erratic slide control), first check if the micro USB receiver dongle is plugged in to the computer USB port, then verify that the presenter is within the range (up to 70 feet) from your computer. If the connection is lost it can be fixed by following the instructions in the Connecting the Presenter to the Computer section to reconnect the devices. • Remember to retrieve the micro USB receiver dongle from the computer and store it in the storage compartment when not in use. Warranty: SMK-LINK Electronics warrants to the original end-user purchaser of the Product (“you”) that the Product, excluding batteries, will be free from defects in materials or workmanship under normal use and service for one-year from date of purchase. Dated invoice or sales receipt is necessary to accompany the Product returned Page 11

for warranty service consideration. Any Product repaired or replaced under the terms of the warranty is covered for the remainder of the original warranty period or ninety (90) days from the date of service or return shipping, whichever is longer. If the Product becomes defective in materials or workmanship during the warranty period, SMK-LINK Electronics will, at its option, either repair or replace it with a more current or upgraded model if the originally purchased model is not available. This warranty does not cover products which have been subjected to misuse, accident, physical damage, improper installation, abnormal operation or handling, neglect, inundation or fire, or when product regulatory label has been removed, altered or rendered illegible; nor does it cover accessory and consumable items. In no case shall SMK-LINK Electronics be liable for any indirect special, incidental, or consequential damages based upon breach of warranty, breach of contract, negligence, strict tort or any other legal theory. Such damages include, but are not limited to, loss of profits, loss of savings or revenues, inability to use the product or any associated equipment, cost of capital, cost of any substitute equipment, facilities or services, claims by third parties other than you, and injury to property. SMK-LINK Electronics’s total liability for damages for any cause related to, or arising out of, the use or inability to use the product, shall not exceed the original price paid for the product even if SMK-LINK Electronics has been informed of such possibility. If your Product requires warranty service, you must first contact SMK-LINK Electronics Product Support to receive an RMA Number. The contact information can be found on SMK-LINK Electronics website: http://www.smklink.com/support/ contactsupport.html. This warranty does not affect your statutory right and you may also have other rights which vary from state to state. Unless modified in writing, signed by both you and SMK-LINK Electronics, this Page 12

warranty is understood to be the complete and exclusive agreement between the parties, superseding all prior agreements, oral or written, and all other communications between the parties relating to the subject matter of this warranty. Product Support SMK-Link Electronics Corporation 3601-B Calle Tecate, Camarillo, CA 93012 TEL: (888) 696-3500 FAX: (805) 987-6665 Laser Warning The LASER button located at the center of the control disc activates a laser which emits a red laser beam from the front of the presenter unit. It is typically used as a pointer during presentations. The laser beam emits for the duration that you press the button. Caution Do not stare into laser beam for it can cause harm to your eyes. Do not aim the laser at people and procedures other than those specified therin may result in hazardous radiation exposure. FDA Compliance for Class 2 Laser CFR21 SUBCHAPTER J EN 60825-1:1994+A1+A2 Page 13

Thank You Thank you for purchasing the Wireless Presenter with Laser Pointer. We know you had other choices and we appreciate that you chose Interlink Electronics Wireless Presenter by SMK-LINK for your product needs. So that we may better serve you in the future, please register online at www.smklink.com/ register. © 2008 SMK-LINK Electronics Page 14


Document Created: 2008-05-07 18:02:32
Document Modified: 2008-05-07 18:02:32
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC