User Manual

FCC ID: PRDMU32

Users Manual

Download: PDF
FCCID_2503397

2.4GHz Wireless
Smart Hyper scrolling BlueTrace Mouse
w/Nano Receiver

USER'S GUIDE
Ver.:1.00




CAUTION: To use this product properly, please read the user's guide before installing.


Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:

-      Reorient or relocate the receiving antenna.
-      Increase the separation between the equipment and receiver.
-      Connect the equipment into an outlet on a circuit different from
      that to which the receiver is connected.
-      Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in
this manual. The further RF exposure reduction can be achieved if the
product can be kept as far as possible from the user body or set the device to
lower output power if such function is available.


                                      1


Functional Introduction




1. Left button        6. Hyper Scrolling Switch Key(LED Indicator)
2. Right button       7. Nano Receiver
3. Scrolling Wheel    8. Battery Cover
4. Forward            9. Connect Button
5. Backward           10. ON/OFF Switch

Forward
Press this button to view the next page in your Internet browser.

Backward
Press this button to view the previous page in your Internet browser.

Hyper Scrolling Key (Two scrolling speeds )
a)   Normal Scroll –LED Off
b)   Hyper Scrolling –LED on and off after 10 secs

     *Default is Normal Scroll *

                                    2


Installing the batteries
Step 1: Take the battery cover off.
Step 2: Insert the batteries as shown inside the battery compartment.




                                                                1st   2nd

     Pull




                                                               AAA Battery


Step 3: Replace the cover.
Step 4: Turn on power switch




**Warning:
*Please insert the batteries with the correct position according to the instruction
 labeled on the mouse.

                                          3


Setup the Connection between the Receiver and
the Mouse
1. Insert the batteries into the mouse, then follow the steps below.
2. In the meantime, to open the mouse under the cover, take the nano
   receiver out.




3. Plug the Nano receiver into the USB port on your computer.




4. If the mouse does not work, please put it into pairing mode.
5. Pairing: Re-plug the receiver into the USB port on your computer, then
   press the connect button on the mouse. If the mouse does not work
   after 10 seconds, pair them again. (The receiver has auto pairing
   function).
6. The LED indicator on mouse flashes steadily when it is in pairing
   mode and stops blinking when it is successfully paired with the
   receiver.
                                   4


7. When low battery, the battery indicator on the mouse will start to blink.


         LED Indicator
                                         *Mouse Indicator

                                         LED Blinking
                                         During Pairing (LED OFF when
                                         paired or failed after 10 sec.)

                                          LED Blinks for 10 sec.
                                          Low Battery Warning




                                     5



Document Created: 2015-01-16 15:12:00
Document Modified: 2015-01-16 15:12:00

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC