Users Manual

FCC ID: PRDMU04

Users Manual

Download: PDF
FCCID_1504098

2.4GHz Wireless Optical Mouse w/Nano Receiver Model# : M250R USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1

Functional Introduction ON/OFF Switch LED Indicator Battery Cover Connect Scrolling Wheel Button Right button Left button Nano Receiver Installing the batteries Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Step 4: Turn on power switch. AAA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. 2

Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. Plug the Nano receiver into the USB port on your computer. 3. If the mouse does not work, please put it into pairing mode. 4. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5. The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. 6. When low battery, the battery indicator on the mouse will start to blink. *Mouse Indicator LED Indicator LED is on for 10 sec. Power ON LED Blinks for 10 sec. Low Battery Warning LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) 3


Document Created: 2011-07-15 09:02:27
Document Modified: 2011-07-15 09:02:27
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC