Modular Approval Letter

FCC ID: PPQ-WB101N

Cover Letter(s)

Download: PDF

FCCID_4200483

LITE-ON Technology Corp.
Bldg. C, 90, Chien 1 Rd., Chung-Ho, New Taipei City, 23585, Taiwan

Declaration of the Modular Approval

Applicant / Grantee LITE-ON Technology Corp.
FCC ID: PPQ-WB101N
Model: WB101N

The single module transmitter has been evaluated then tested meeting the requirements
under Part 15C Section 2.12 as below:

Modular approval requirement EUT Condition Comply
(a) The radio elements of the modular The module has shielding. V
transmitter must have their own shielding.
The physical crystal and tuning capacitors
may be located external to the shielded
radio elements.

(b) The modular transmitter must have The module has buffered V
buffered modulation/data inputs (if such modulation/data inputs.
inputs are provided) to ensure that the
module will comply with part 15
requirements under conditions of
excessive data rates or over-modulation.

(c)The modular transmitter must have its The module has its own power supply V
own powersupply regulation. regulation.

(d) The modular transmitter must comply The device has a PIFA antenna which V
with the antenna and transmission system permanently attached and employ a
requirements of Sections 15.203, 15.204(b) unique antenna coupler.
and 15.204(c). The antenna must either be
permanently attached or employ a
“unique” antenna coupler (at all
connections between the module and the
antenna, including the cable). The
“professional installation” provision of
Section 15.203 is not applicable to modules
but can apply to limited modular approvals
under paragraph (b) of this section.

(e)The modular transmitter must be tested The modular transmitter was tested on V
in a stand-alone configuration, i.e., the evaluation board is a stand-alone H/W.
module must not be inside another device
during testing for compliance with part 15

LITE-ON Technology Corp.
Bldg. C, 90, Chien 1 Rd., Chung-Ho, New Taipei City, 23585, Taiwan
requirements. Unless the transmitter
module will be battery powered, it must
comply with the AC line conducted
requirements found in Section 15.207. AC
or DC power lines and data input/output
lines connected to the module must not
contain ferrites, unless they will be
marketed with the module (see Section
15.27(a)). The length of these lines shall be
the length typical of actual use or, if that
length is unknown, at least 10 centimeters
to insure that there is no coupling between
the case of the module and supporting
equipment. Any accessories, peripherals, or
support equipment connected to the
module during testing shall be unmodified
and commercially available (see Section
15.31(i))mustnotbe
insideanotherdeviceduringtesting.

(f)The modular transmitter must be The module equipped with permanently V
equipped with either a permanently affixed label.
affixed label or must be capable of
electronically displaying its FCC
identification number.

(g) The modular transmitter must comply Instruction is included in the V
with any specific rules or operating application.
requirements that ordinarily apply to a
complete transmitter and the manufacturer
must provide adequate instructions along
with the module to explain any such
requirements. A copy of these instructions
must be included in the application for
equipment authorizationrequirements,
which are based on the intended
use/configurations.

(h)The modular transmitter must comply The module complies with any V
with any applicable RF exposure applicable RF exposure requirements in
requirements in its final configuration. its final configuration.

Document Created: 2019-03-05 17:50:02
Document Modified: 2019-03-05 17:50:02

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC