Users Manual_rev.pdf

FCC ID: PPQ-RPT01

Users Manual

Download: PDF
FCCID_4063209

Repeater Installation 1. Plug lug Repeater to adaptor. 2. Each room needs a Repeater installed. If the signal needs pass to different floor, you will need Repeater installed around the stairs as well.  Repeater eater Specification NO Item Specification 1 Power source 5V, 1A, USB A type plug 2 Radio type Proprietary 2.4G RF 3 Power consumption <150mW 4 Operation temperature 0°C~45°C 5 Storage temperature -30°C~70°C 6 Dimension (mm) L64.85 x W18 x H9 7 Weight (g) 7.2g Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are desi designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference terference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment quipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.


Document Created: 2018-11-05 15:54:36
Document Modified: 2018-11-05 15:54:36
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC