Modular Approval Letter

FCC ID: PPD-AR5BXB61

Cover Letter(s)

Download: PDF
FCCID_596225

                           Atheros Communications, Inc.
                         FCC ID: PPD-AR5BXB61
                       Request for transmitter modular approval

                          Transmitter Module Characteristics

Item                     Requirements                                      EUT
  1    Have its own RF shielding                                Device is equipped with
                                                                Metal shielding to cover
                                                                  RF section. Refer to
                                                                     external photos
 2     Have buffered modulation/data inputs (if such            All inputs to the modules
       inputs are provided),                                   are buffered through logic
                                                               or microprocessor inputs.
 3     Have it own power supply regulation                         The transmitter has
                                                                its own power supply
                                                                     regulator.

 4     Meet the antenna requirements of Section                 Device is equipped with
       15.203                                                  unique antenna ( u.FL(v)-
                                                               LP-040) connector. Refer
                                                                   to external photos
 5     Be tested in a stand-alone configuration, i.e., the     Device was tested outside
       antenna, AC or DC power and data input/output             the laptop for modular
       lines must be connected to the module but, the           approval. Refer to setup
       module must not be inside another case during                     photos.
       testing
 6     Be labeled with its own FCC ID number, and if              Two proposed FCC ID
       the FCC ID is not visible when the module is             label format are included
       installed inside another device, then the outside        in the filing. One label
       of the device into which the module is installed           is to be placed on the
       must also display a label referring to the                 module and the other
       enclosed module.                                        label is to be placed on the
                                                               outside of system. Refer to
                                                                FCC ID label format and
                                                                       location file.
 7     The modular transmitter is manufactured so that          Refer to “User’s Guide”
       the user cannot influence the operation of the                      Exhibit
       transmitter that will operate outside of the scope
       of the regulations.
 8     Address compliance with the Commission's RF                Transmitter meets
       exposure limits in Sections 1.1310 and 2.1093.                MPE calculations
       In addition, spread spectrum transmitters                 of 47 CFR 1.1307(b)(1).
       operating under Section 15.247 are required to            Refer to MPE sections of
       address RF exposure compliance in accordance              test reports
       with Section 15.247(b)(4).



Document Created: 2005-10-07 15:03:00
Document Modified: 2005-10-07 15:03:00

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC