Modular approval request letter

FCC ID: PPD-AR5BHB63

Cover Letter(s)

Download: PDF
FCCID_888910

           Atheros Communications, Inc.
                           Atheros Communications, Inc.
                            FCC ID : PPD-AR5BHB63
                       Request for transmitter modular approval

                           Transmitter Module Characteristics

Item                     Requirements                                       EUT
  1    Have its own RF shielding                                 Device is equipped with
                                                                 Metal shielding to cover
                                                                   RF section. Refer to
                                                                      external photos
 2     Have buffered modulation/data inputs (if such             All inputs to the modules
       inputs are provided),                                    are buffered through logic
                                                                or microprocessor inputs.
 3     Have it own power supply regulation                          The transmitter has
                                                                 its own power supply
                                                                      regulator.

 4     Meet the antenna requirements of Section                  Device is equipped with
       15.203                                                   unique antenna ( u.FL(v)-
                                                                LP-040) connector. Refer
                                                                    to external photos
 5     Be tested in a stand-alone configuration, i.e., the      Device was tested outside
       antenna, AC or DC power and data input/output              the laptop for modular
       lines must be connected to the module but, the            approval. Refer to setup
       module must not be inside another case during                      photos.
       testing
 6     Be labeled with its own FCC ID number, and if            Two proposed FCC ID
       the FCC ID is not visible when the module is           label format are included
       installed inside another device, then the outside      in the filing. One label
       of the device into which the module is installed         is to be placed on the
       must also display a label referring to the               module and the other
       enclosed module.                                      label is to be placed on the
                                                             outside of system. Refer to
                                                              FCC ID label format and
                                                                     location file.
 7     The modular transmitter is manufactured so that        Refer to “User’s Guide”
       the user cannot influence the operation of the                    Exhibit
       transmitter that will operate outside of the scope
       of the regulations.
 8     Address compliance with the Commission's RF                Transmitter meets
       exposure limits in Sections 1.1310 and 2.1093.                MPE calculations
       In addition, spread spectrum transmitters                 of 47 CFR 1.1307(b)(1).
       operating under Section 15.247 are required to            Refer to MPE sections of
       address RF exposure compliance in accordance              test reports
       with Section 15.247(b)(4).



Document Created: 2007-12-20 17:01:42
Document Modified: 2007-12-20 17:01:42

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC