Response to ATCB

FCC ID: PL6-BTS-R3

Cover Letter(s)

Download: PDF

FCCID_386766

FCC ID: PL6-BTS-R3_ATCB000941 Responses

1. The tune-up procedure is password protected so changes can not be made, the
document can be opened as "Read Only". If this is not acceptable, a .pdf version can be
provided.
2. There are two label exhibits provided. One is the label location which shows the location
of the label on the device. The other is the actual label, which shows the label clearly.
3. A new Request for confidentiality has been uploaded. Please include the tune-up
procedure as confidential. Please remove the block diagram from the submission as per
section 2.1033(c) it is not required.
4. Per CFR 47, 2.1033(c), a parts list is not required.
5. The test report indicates a measured value of 38dBm, the MPE calculations were
performed using the measured 38dBm value. The Operational Description indicates a
maximum of 39dBm at the RFM (RF Module). If you refer to the diagram at the top of
page 2, you will note where the RFM is located. The maximum power output at the RFS
is 38dBm.
6. 2.1091(d)(2) indicates that source-based time averaging may be used based on an
inherent property or duty-cycle of a device. This device uses TDD technology and
therefore is allowed to use source-based time averaging, which is 50% or 75% for this
device.
7. Updated MPE calculation have been uploaded
8. Please see updated manual
9. There are Two FETs in the same package operating at 12.6V and 1.2Amp
10. Updated Test Report uploaded
11. Test method added to test report
12. See emission limitation mask under 21.106. Client held off on submission of product.
13. Updated Test Report has been uploaded
14. The test diagram provided in the test report was incorrect, an updated Test Report has
been provided showing the correct test setup.

Document Created: 2004-01-07 07:47:21
Document Modified: 2004-01-07 07:47:21

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC