1901RSU031-U3-FCC-Co-location-Test-Report

FCC ID: PBR-SZG3ACWC

Test Report

Download: PDF
FCCID_4155940

                                       MRT Technology (Suzhou) Co., Ltd         Report No.: 1901RSU031-U3
                                       Phone: +86-512-66308358                  Report Version:        V01
                                       Web: www.mrt-cert.com                    Issue Date:     01-22-2019




                                 Co-location Report

Applicant:                     The Kroger Co.

Address:                       11450, Grooms Road, Blue Ash OH-45242 United States



Application Type:              Certification

Product:                       GEN3Z Camera and WiFi_Wave2_Zigbee Access Point
                               Unit
Model No.:                     SZG3ACWC

FCC Rule Part(s):              Part 15 Subpart C (Section 15.247)
                               Part15 Subpart E (Section 15.407)
Test Date:                     January 13 ~ 22, 2019




Reviewed By:
                                  ( Jame Yuan )
Approved By:
                                   ( Robin Wu )




The test results relate only to the samples tested.
This equipment has been shown to be capable of compliance with the applicable technical standards as
indicated in the measurement report and was tested in accordance with the measurement procedures specified
in ANSI C63.10-2013. Test results reported herein relate only to the item(s) tested.
The test report shall not be reproduced except in full without the written approval of MRT Technology (Suzhou)
Co., Ltd.
 FCC ID: PBR-SZG3ACWC                                                                       Page Number: 1 of 6


                                                     Report No.: 1901RSU031-U3




                             Revision History

   Report No.     Version        Description      Issue Date           Note

1901RSU031-U3      Rev. 01       Initial Report   01-22-2019           Valid




FCC ID: PBR-SZG3ACWC                                           Page Number: 2 of 6


                                                                                  Report No.: 1901RSU031-U3



 1.    TEST RESULT of Radiated Emissions for Co-located
 Test Mode:          2.4GHz Wi-Fi + 2.4GHz BT + 2.4G         Test Site:             AC1
                     ZigBee + 5GHz Wi-Fi Transmit
 Test Engineer:      Max Wang                                Polarity:              Horizontal
 Remark:             There is the ambient noise within frequency range 9kHz~30MHz and
                     18GHz~40GHz, the permissible value is not show in the report.




 No   Flag    Mark   Frequency   Measure     Reading      Over Limit     Limit        Factor      Type
                     (MHz)       Level       Level        (dB)           (dBuV/m)     (dB)
                                 (dBuV/m)    (dBuV)
 1                   6907.500    51.222      40.375       -16.978        68.200       10.847      PK
 2                   7213.500    60.471      47.824       -7.729         68.200       12.647      PK
 3                   9109.000    49.227      35.486       -24.773        74.000       13.741      PK
 4                   9109.000    37.271      23.530       -16.729        54.000       13.741      AV
Note 1: Measure Level (dBμV/m) = Reading Level (dBμV) + Factor (dB)
Factor (dB) = Cable Loss (dB) + Antenna Factor (dB/m) - Pre_Amplifier Gain (dB).
Note 2: We selected the 2.4GHz and 5GHz worst-case mode of radiated spurious emissions in the DTS, DSS
and UNII reports.
Note 3: 2.4GHz Wi-Fi 802.11b Channel 2412MHz Power setting = 20; 5GHz Wi-Fi 802.11ac-VHT20 Channel
5805MHz Power setting = 20; 2.4GHz Bluetooth module transmitting; Three ZigBee modules transmitting;




FCC ID: PBR-SZG3ACWC                                                                      Page Number: 3 of 6


                                                                                  Report No.: 1901RSU031-U3




 Test Mode:          2.4GHz Wi-Fi + 2.4GHz BT + 2.4G         Test Site:             AC1
                     ZigBee + 5GHz Wi-Fi Transmit
 Test Engineer:      Max Wang                                Polarity:              Vertical
 Remark:             There is the ambient noise within frequency range 9kHz~30MHz and
                     18GHz~40GHz, the permissible value is not show in the report.




 No   Flag    Mark   Frequency   Measure     Reading      Over Limit     Limit         Factor      Type
                     (MHz)       Level       Level        (dB)           (dBuV/m)      (dB)
                                 (dBuV/m)    (dBuV)
 1                   6907.500    48.562      37.715       -19.638        68.200        10.847      PK
 2                   7213.500    60.564      47.917       -7.636         68.200        12.647      PK
 3                   9848.500    56.675      39.990       -11.525        68.200        16.684      PK
Note 1: Measure Level (dBμV/m) = Reading Level (dBμV) + Factor (dB)
Factor (dB) = Cable Loss (dB) + Antenna Factor (dB/m) - Pre_Amplifier Gain (dB).
Note 2: We selected the 2.4GHz and 5GHz worst-case mode of radiated spurious emissions in the DTS, DSS
and UNII reports.
Note 3: 2.4GHz Wi-Fi 802.11b Channel 2412MHz Power setting = 20; 5GHz Wi-Fi 802.11ac-VHT20 Channel
5805MHz Power setting = 20; 2.4GHz Bluetooth module transmitting; Three ZigBee modules transmitting;




                                                  The End


FCC ID: PBR-SZG3ACWC                                                                       Page Number: 4 of 6


                                     Report No.: 1901RSU031-U3




Appendix A - Test Setup Photograph
Refer to “1901RSU031-UT” file.




FCC ID: PBR-SZG3ACWC                        Page Number: 5 of 6


                                  Report No.: 1901RSU031-U3




Appendix B - EUT Photograph
Refer to “ 1901RSU031-UE” file.




FCC ID: PBR-SZG3ACWC                     Page Number: 6 of 6



Document Created: 2019-01-28 11:43:11
Document Modified: 2019-01-28 11:43:11

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC