Test Report Part 2

FCC ID: PANWL2203

Test Report

Download: PDF
FCCID_483143

FCC ID: PANWL2203 4.4.3 TEST PROCEDURES 1. A detector was used on the output port of the EUT. An oscilloscope was used to peak the response of the detector. 2. Replaced the EUT by the signal generator. The center frequency of the S.G was adjusted to the center frequency of the measured channel. 3. Adjusted the power to have the same peak reading on oscilloscope. Record the power level. 4.4.4 DEVIATION FROM TEST STANDARD No deviation 4.4.5 TEST SETUP EUT or S.G DETECTOR OSCILLOSCOPE 4.4.6 EUT OPERATING CONDITIONS Same as Item 4.3.6 Report No.: RF931004L01 41 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.4.7 TEST RESULTS (A) EUT WLAN 11g USB Adapter MODEL WL-2203 INPUT POWER ENVIRONMENTAL 23 deg. C, 67% RH, 120 Vac, 60 Hz (SYSTEM) CONDITIONS 991 hPa TESTED BY Leo Hung PEAK PEAK CHANNEL PEAK POWER POWER POWER CHANNEL FREQUENCY OUTPUT PASS/FAIL OUTPUT LIMIT (MHz) (mW) (dBm) (dBm) 1 2412 11.066 10.44 30 PASS 6 2437 11.092 10.45 30 PASS 11 2462 11.143 10.47 30 PASS 4.4.8 TEST RESULTS (B) EUT WLAN 11g USB Adapter MODEL WL-2203 INPUT POWER ENVIRONMENTAL 23 deg. C, 67% RH, 120 Vac, 60 Hz (SYSTEM) CONDITIONS 991 hPa TESTED BY Leo Hung PEAK PEAK CHANNEL PEAK POWER POWER POWER CHANNEL FREQUENCY OUTPUT PASS/FAIL OUTPUT LIMIT (MHz) (mW) (dBm) (dBm) 1 2412 11.143 10.47 30 PASS 6 2437 11.169 10.48 30 PASS 11 2462 11.169 10.48 30 PASS Report No.: RF931004L01 42 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.5 POWER SPECTRAL DENSITY MEASUREMENT 4.5.1 LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT The Maximum of Power Spectral Density Measurement is 8dBm. 4.5.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until SPECTRUM ANALYZER FSEK30 100049 Aug. 12, 2005 NOTE: The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. Report No.: RF931004L01 43 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.5.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer through an attenuator, the bandwidth of the fundamental frequency was measured with the spectrum analyzer using 3kHz RBW and 30kHz VBW, set sweep time=span/3kHz. The power spectral density was measured and recorded. The sweep time is allowed to be longer than span/3kHz for a full response of the mixer in the spectrum analyzer. 4.5.4 DEVIATION FROM TEST STANDARD No deviation 4.5.5 TEST SETUP EUT SPECTRUM ANALYZER 4.5.6 EUT OPERATING CONDITIONS Same as 4.3.6 Report No.: RF931004L01 44 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.5.7 TEST RESULTS (A) EUT WLAN 11g USB Adapter MODEL WL-2203 INPUT POWER ENVIRONMENTAL 23 deg. C, 67% RH, 120 Vac, 60 Hz (SYSTEM) CONDITIONS 991 hPa TESTED BY Leo Hung CHANNEL RF POWER LEVEL IN MAXIMUM CHANNEL FREQUENCY 3KHz BW LIMIT PASS/FAIL NUMBER (MHz ) (dBm) (dBm) 1 2412 -11.98 8 PASS 6 2437 -11.08 8 PASS 11 2462 -10.34 8 PASS Report No.: RF931004L01 45 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH1 Report No.: RF931004L01 46 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH6 Report No.: RF931004L01 47 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH11 Report No.: RF931004L01 48 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.5.8 TEST RESULTS (B) EUT WLAN 11g USB Adapter MODEL WL-2203 INPUT POWER ENVIRONMENTAL 23 deg. C, 67% RH, 120 Vac, 60 Hz (SYSTEM) CONDITIONS 991 hPa TESTED BY Leo Hung CHANNEL RF POWER LEVEL IN MAXIMUM CHANNEL FREQUENCY 3KHz BW LIMIT PASS/FAIL NUMBER (MHz ) (dBm) (dBm) 1 2412 -21.65 8 PASS 6 2437 -21.41 8 PASS 11 2462 -21.97 8 PASS Report No.: RF931004L01 49 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH1 Report No.: RF931004L01 50 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH6 Report No.: RF931004L01 51 Issued: Oct. 21, 2004

FCC ID: PANWL2203 CH11 Report No.: RF931004L01 52 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.6 BAND EDGES MEASUREMENT 4.6.1 LIMITS OF BAND EDGES MEASUREMENT Below –20dB of the highest emission level of operating band (in 100kHz Resolution Bandwidth). 4.6.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until SPECTRUM ANALYZER FSEK30 100049 Aug. 12, 2005 NOTE: The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. 4.6.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer via a low lose cable. Set both RBW and VBW of spectrum analyzer to 100kHz with suitable frequency span including 100MHz bandwidth from band edge. The band edges was measured and recorded. 4.6.4 DEVIATION FROM TEST STANDARD No deviation 4.6.5 EUT OPERATING CONDITION Same as Item 4.3.6 Report No.: RF931004L01 53 Issued: Oct. 21, 2004

FCC ID: PANWL2203 4.6.6 TEST RESULTS The spectrum plots are attached on the following 8 pages. D2 line indicates the highest level, D1 line indicates the 20dB offset below D2. It shows compliance with the requirement in part 15.247(C). 4.6.7 TEST RESULTS(A) NOTE: The band edge emission plot of CCK technique on the following 1~2 pages show 53.28dB delta between carrier maximum power and local maximum emission in restrict band (2.3869GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2.8 is 98.88dBuV/m, so the maximum field strength in restrict band is 98.88-53.28=45.60dBuV/m which is under 54dBuV/m limit. The band edge emission plot of CCK technique on the following 3~4 pages show 56.83dB delta between carrier maximum power and local maximum emission in restrict band (2.4885GHz). The emission of carrier strength list in the test result of channel 11 at the item 4.2.8 is 97.24dBuV/m, so the maximum field strength in restrict band is 97.24-56.83=40.41dBuV/m which is under 54dBuV/m limit. 4.6.8 TEST RESULTS(B) NOTE: The band edge emission plot of OFDM technique on the following 5~6 pages show 42.49dB delta between carrier maximum power and local maximum emission in restrict band (2.3895GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2.9 is 96.02dBuV/m, so the maximum field strength in restrict band is 96.02-42.49=53.53dBuV/m which is under 54dBuV/m limit. The band edge emission plot of OFDM technique on the following 7~8 pages show 45.17dB delta between carrier maximum power and local maximum emission in restrict band (2.4835GHz). The emission of carrier strength list in the test result of channel 11 at the item 4.2.9 is 95.14dBuV/m, so the maximum field strength in restrict band is 95.14-45.17=49.97dBuV/m which is under 54dBuV/m limit. Report No.: RF931004L01 54 Issued: Oct. 21, 2004

Harken 1. CT1] raw 100 ie Ar ar 20 as 0.54 aam vau 100 kitz aon 2.41270387 Gie SuT 25 no unit cBin orrse "Tm] ase| aite 33 5 walfera d na Lis as hes wvigu ina —z —z0 «o WWW «o B Conter 2 n Gnz

4 zzus se— be— wus 33 ou 1 sesmy

Harker 1. CTH] rou 100 119 aBn vou 100 kiz 10.5 dbm 2.48101403 one sut 25 ns Un ho Ghe 33 poo B «_ 1% #alom stol Gre t hn w |or ce uen ina —ao «o ‘ = WMW 10 ritz, Span 100 mz B

mi Rew 100 khz met 58.07 aan veu 100 kxz a.00977955 Ghe sur Lo cb asn 33 20 |—o9 bis.s: hon ivigu ina —«ol —sol l o 2.5 hz 2.25 Gizz Stop 25 6nz B

farker 1. CT1] Rou 100 kiz AF art 20 ca —7.74 dBn vBu 100 kn 2.41358317 one Sut 25 ns unit don 33 Lor —7.)re s —z wvigu 7 h |——02 }27.71 ina h [ w pull) —sol «o «o a4 I B 6£

/ on ;3?%323 " _____

Harker 1. C711 art 20 as Ret —7.98 abn 10.5 aon 2.45s41583 one aon 10. T—5 op omm 33 >.«835dpoo. oi «ad 2. aa3roba0 oc m ad. ien ina 02 |2r.98 h cao —so —so ao —as Center 2.501 Giz 10 thic too riz B

Marker 1 (T1) gau 100 kiz RF it 20 08 Ref L —52.25 ctn ou 100 kiz 10.5 as «.essrzase Gre sut 5.8 8 unit atn 105 Ts ob ons 33 Lor —7.J93 can wvigu ina 2 |—2z.so hon «xo sc . # WMWJ‘MM hy[Aowad «o as.st Stant 2.5 GHz 2.25 Giz, Stop 25 6Nz B

FCC ID: PANWL2203 4.7 ANTENNA REQUIREMENT 4.7.1 STANDARD APPLICABLE For intentional device, according to FCC 47 CFR Section 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. And according to FCC 47 CFR Section 15.247 (b), if transmitting antennas of directional gain greater than 6dBi are used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6dBi. 4.7.2 ANTENNA CONNECTED CONSTRUCTION The antenna used in this product is chip antenna without connector. And the maximum Gain of this antenna is 1.98dBi. Report No.: RF931004L01 63 Issued: Oct. 21, 2004

FCC ID: PANWL2203 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST Report No.: RF931004L01 64 Issued: Oct. 21, 2004

FCC ID: PANWL2203 RADIATED EMISSION TEST Report No.: RF931004L01 65 Issued: Oct. 21, 2004

FCC ID: PANWL2203 6 INFORMATION ON THE TESTING LABORATORIES We, ADT Corp., were founded in 1988 to provide our best service in EMC, Radio, Telecom and Safety consultation. Our laboratories are accredited and approved by the following approval agencies according to ISO/IEC 17025, Guide 25 or EN 45001: USA FCC, NVLAP, UL, A2LA Germany TUV Rheinland Japan VCCI Norway NEMKO Canada INDUSTRY CANADA , CSA R.O.C. CNLA, BSMI, DGT Netherlands Telefication Singapore PSB , GOST-ASIA(MOU) Russia CERTIS(MOU) Copies of accreditation certificates of our laboratories obtained from approval agencies can be downloaded from our web site: www.adt.com.tw/index.5/phtml. If you have any comments, please feel free to contact us at the following: Linko EMC/RF Lab: Hsin Chu EMC/RF Lab: Tel: 886-2-26052180 Tel: 886-3-5935343 Fax: 886-2-26052943 Fax: 886-3-5935342 Hwa Ya EMC/RF/Safety/Telecom Lab: Linko RF Lab. Tel: 886-3-3183232 Tel: 886-3-3270910 Fax: 886-3-3185050 Fax: 886-3-3270892 Web Site: www.adt.com.tw The address and road map of all our labs can be found in our web site also. Report Format Version 1.5 Report No.: RF931004L01 66 Issued: Oct. 21, 2004


Document Created: 2004-10-26 20:12:20
Document Modified: 2004-10-26 20:12:20
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC