User Manual

FCC ID: PAGTR-026S

Users Manual

Download: PDF
FCCID_3744227

TR-026S Remote Controller User Manual BACK OUTDOOR 3-OUTLET TIMER 2. Timer and remote interaction Your timer includes a remote control with temporary 2 SAFETY INFORMATION override: RECEIVER MODEL: TM-069R WITH REMOTE CONTROL • Temporary override ON: turns the timer ON for desired settings (2, 4, 6 or TRANSMITTER MODEL: TR-026S FCC ID: PAGTR-026S WARNING: 8 Hours). Please note that if the timer is set to a 2-, IC: 4494A-TR026S • The device must be mounted in a vertical position with the receptacle facing 4-, 6- or 8-hour mode, it will come on at dusk and SPECIFICATIONS: downward and with the receptacle at least 1.4 M above the ground level. will turn off 2, 4, 6, or 8 hours later. 14/3 AWG SJTW vinyl cord • Let the switch hang downward so moisture does not accumulate in the outlet. • Temporary override OFF: turns the timer OFF. • Suitable for Outdoor Use, Store indoors when not in use. Not for water RATINGS: Timer Dial position Using the Remote immersion or for use were directly exposed to water 125 V ac 60 Hz, OFF Press the remote and the timer will turn ON/OFF 15 A Resistive, INSTALLATION INSTRUCTIONS ON Press the remote and the timer will turn ON/OFF 15 A General Use, 1,000 W Tungsten, DUSK-DAWN Press the remote and it will go into a manual Installation 500 VA Electronic Ballast, 2, 4, 6 or 8 HRS restart mode. The timer will restart from ‘0’ and a. Mount the timer onto a wall near a grounded 1/2HP. 120 V ac 60 Hz, 8.3 A Ballast count until it reaches the time set on the dial, or electrical outlet with the photo sensor facing dawn. Please refer to examples below for further Federal Communications Commission Interference Statement outward. explanation. This equipment has been tested and found to comply with the limits for Class Note: To ensure proper operation of automatic B digital device, pursuant to part 15 of the FCC Rules. These limits are function, ensure photocell sensor is shielded 3. Examples designed to provide reasonable protection against harmful interference in a from all nighttime sources of light, i.e. 3 • Timer set to DUSK-DAWN When DUSK = 6:00 PM residential installation. This equipment generates, uses and can radiate radio floodlights. and DAWN = 5:00 AM. frequency energy and, if not installed and used in accordance with the b. Insert nail or screw (not included) into mounting - If at 4 :00 PM REMOTE activated to ON --> TIMER instructions, may cause harmful interference to radio or television reception, surface. Nail or screw head must extend at least 3/16 in. out from the OUTPUT ON and stays ON until 5:00 AM. which can be determined by turning the equipment off and on, the user is wall. Hang the receiver from the slot on back of the unit onto the nail or - Next day, ON at DUSK, OFF at DAWN. encouraged to try to correct the interference by one or more of the following screw. Plug the power supply cord of the receiver into the outlet. - If at 10:00 PM REMOTE activated to OFF --> TIMER measures: c. Plug the device cord into any of the three receptacles at the bottom of OUTPUT OFF = 10:00 PM and stays OFF until the receiver. • Reorient or relocate the receiving antenna. DAWN next day. • Increase the separation between the equipment and the receiver. - Next day ON at DUSK, OFF at DAWN. • Connect the equipment into an outlet on a circuit different from that to which OPERATING INSTRUCTIONS • If TIMER setting is 2 HOURS (or 4, 6, 8 HOURS and so on) DAY OR the receiver is connected. NIGHT TIME REMOTE ON --> TIMER OUTPUT ON 2 HOURS (4, 6, 8 • Consult the dealer or an experienced radio/TV technician for help. 1. Button Layout HOURS) then OFF. When DUSK --> TIMER OUTPUT ON 2 HOURS (4, 6, 8 HOURS) then This device complies with Part 15 of the FCC Rules. Operation is subject to the OFF. If DUSK is at 6:00 PM: following two conditions: (1) This device may not cause harmful interference, (1) If at 5:00 PM REMOTE set ON, then TIMER OUTPUT ON immediately and (2) this device must accept any interference received, including until 7:00 PM. interference that may cause undesired operation of the device. (2) TIMER ON = 6:00 PM, TIMER OFF = 8:00 PM. If at 1:00 PM REMOTE set ON, then TIMER OUTPUT turns ON until 3:00 PM. FCC Caution: Any changes or modifications not expressly approved by the Receiver (3) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set ON TIMER OUTPUT party responsible for compliance could void the user's authority to operate this ON until 9:00 PM (as time count restarted at time remote activates to equipment. ON). 1 3 (4) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set OFF, then TIMER Industry Canada statement: ON OUTPUT turns OFF immediately until next day. This Class B digital apparatus complies with Canadian ICES-003. OFF This device complies with Industry Canada license-exempt RSS standard(s). 2 4 5 MAINTENANCE Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, Battery Handling and Usage including interference that may cause undesired operation of the device. Transmitter WARNING: Keep batteries away from children and pets. Le présent appareil est conforme aux CNR d'Industrie Canada applicables • Follow the battery manufacturer’s safety and usage instructions. aux appareils radio exempts de licence. L'exploitation est autorisée aux deux • Insert the battery observing the proper polarity (+/-) as indicated inside conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) Battery Compartment. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, • Remove a spent or discharged battery from the product. Remove the même si le brouillage est susceptible d'en compromettre le fonctionnement. battery when not using the product for an extended period. WARNING:This product can expose you to DINP which is known to the 6 • Never throw batteries into a fire. Do not expose batteries to fire or other State of California to cause cancer and birth defects or other heat sources. reproductive harm. For more information go to • Dispose or recycle spent / discharged batteries in compliance with all www.P65Warnings.ca.gov. applicable laws. For detailed information contact your local solid waste TROUBLESHOOTING 1. Timer unit: The timer will control an array of devices by setting the dial. authority. 2. Remote control: • Battery contains mercury. Do not put in trash. Recycle or manage as Solution • ON: When the on button is pressed, it will override the timer’s current hazardous waste. The lights do not turn on, Ensure the lights are functional by plugging them directly program to on function. even when the timer is in into the outlet. • OFF: When the off button is pressed, it will override the timer’s current the “ON” position. Be sure that the lights are in the “ON” position if they have program to off function. CAUTION: Failure to properly align the battery polarity can cause personal injury and/or property damage. their own switch. • Remote indicator light: The LED light indicates that the ON or OFF Be sure that the outlet that the timer is plugged into is button is being pressed. Problem active. 3. Timer dial: Rotate the dial on the timer to select one of the following settings Replacing the battery • Remove the Battery compartment cover from the back Be sure that the dial is fully turned to the “ON” position by Dial position Function listening for the clicking sound. of the remote control by sliding the cover in the The lights do not turn on Confirm that the timer is plugged properly into the outlet, OFF Power OFF direction that its trends curve. 2,4,6, or 8 hrs. after dusk. and that the light is turned on if there is a switch. ON Power ON • Remove the spent battery and place a new DC 12V Type A23 battery into the Battery Compartment Be sure that the timer is not near ambient light sources. DUSK-DAWN Powers ON at dusk, OFF at dawn correctly observing the polarity indications (+/-) inside The lights do not turn on 2 Hrs ON at dusk – OFF in 2 hours the Battery Compartment. and off via remote control. Confirm remote operation after replacing batteries. 4 Hrs ON at dusk – OFF in 4 hours • Replace the Battery Compartment Cover. 6 Hrs ON at dusk – OFF in 6 hours • Clear the battery contacts and also those of the device Made in China prior to battery installation SAVE THESE INSTRUCTIONS! 8 Hrs ON at dusk – OFF in 8 hours 4. Power indicator light: The power indicator light indicates that the timer is HELPFUL TIPS on. 5. Photo sensor: The sensor will sense for light and dark, and direct the • Before using your timer, please read the following instructions carefully. timer to act accordingly. • When set to “ON”, the timer will provide continual power to attached devices 6. Outlets: The three outlets located on the button of the timer allows the until the timer is switched to “OFF”, or to any of the other operating modes. user to plug an array of devices into it. SAVE THESE INSTRUCTIONS!


Document Created: 2018-02-06 11:40:02
Document Modified: 2018-02-06 11:40:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC