user manual

FCC ID: PAGTR-026A

Users Manual

Download: PDF
FCCID_4285979

TR-026A Remote Controller User Manual CAUTION: Failure to properly align the battery polarity can cause personal injury and/or Cet appareil est conforme à l'article 15 du règlement de la FCC. Son utilisation est sujette aux IMPORTANT SAFEGUARDS property damage. deux conditions suivantes : (1) L'appareil ne doit pas être la cause d'interférences nuisibles, et (2) L'appareil doit accepter toutes les interférences, y compris celles pouvant entraîner un NOTE: These are general definitions only; all may not pertain to the actual product purchased. Replacing the battery Replacing the battery fonctionnement indésirable. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in • Remove the Battery compartment cover from the back death or serious injury. Usage of this signal word is limited to the most extreme situations. of the remote control. ATTENTION: Toute modification non autorisée expressément par la partie responsable de la WARNING: Indicates potentially hazardous situation, which, if not avoided, may result in • Remove the spent battery and place a new Type conformité peut annuler le droit de l’utilisateur de se servir de cet appareil. minor / moderate injury or product/ property damage. It also alerts against unsafe practices. CR2032 battery into the Battery Compartment correctly CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in observing the polarity indications (+/-) inside Déclaration d’Industrie Canada : the Battery Compartment. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le présent minor/moderate injury or product/ property damage. It also alerts against unsafe practices. • Replace the Battery Compartment Cover. appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de • Clear the battery contacts and also those of the device licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas When using electrical products, always follow basic prior to battery installation produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique safety precautions including the following: subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. To Set Up Purpose of control : 1. Mount the Receiver near a three-prong, grounded, standard 125-volt AC electrical outlet: • Operating Control a. Choose a location on the wall to insert a nail or wood screw (not included) for mounting the • Cord-connected Receiver. Please note the following when choosing the location: • When hung from the nail/screw, the Receiver must be close enough to the outlet for the WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov cord to plug into the outlet. • The device must be mounted vertically with its outlets facing downward and not reaching ground level. WARNING: b. Insert the nail/screw into the wall in the chosen location. The nail or screw head must • Suitable for outdoor use, store indoors while not in use. • This device must be mounted in a vertical position with the receptacle facing downward and WARNING-- To reduce the risk of fire, electric shock, or extend at least 3/16” from the wall. with the receptacle at least 2 feet above the ground level not for water immersion. serious personal injury c. Hang the keyhole of the Receiver on the nail or screw. 2. Plug the Receiver into a standard 125-volt AC electrical outlet. • Do not immerse the product in liquids 3. Confirm that the electrical specifications of an item you wish to use with this product do not • Do not use an electrical device or appliance with this exceed those specified in the “Electrical Specifications” section. Plug the item into an outlet of product whose electrical specifications exceed those the Receiver. specified in the “Electrical Specifications” section of this 4. Remove the plastic battery tab from the Battery Compartment in the back of the Remote manual. Control to activate the Type CR2032 pre-installed battery. • For Indoor/Outdoor use. 5. The device must be mounted in a vertical position with the receptacle facing downward and with the receptacle at least 2 feet above the ground level not for water immersion. CAUTION-- To reduce the risk of personal injury or product/ property damage: To Use • This product is intended for non-commercial, non-industrial Remote Control: use in the remote control of two electrical outlets. 1. To activate the Receiver, press the ON Button of the Remote Control. The red LED of the Do not use this product for any other purpose. Remote Control will illuminate momentarily. NOTE: The Remote Control must be within 100 feet of the Receiver. Features: Controls one electrical outlet up to a distance of 100 feet. 2. To turn the Receiver off, press the OFF Button of the Remote Control. Caution: • Always purchase the correct size and grade of battery most suitable for the intended use. Federal Communications Commission Interference Statement This equipment has been tested and found to comply with the limits for Class B digital device, • Replace all batteries of a set at the same time. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable • Clean the battery contacts and also those of the device prior to battery installation. protection against harmful interference in a residential installation. This equipment generates, • Ensure the batteries are installed correctly with regard to polarity (+and -). uses and can radiate radio frequency energy and, if not installed and used in accordance with • Remove batteries from equipment with is not to be used for an extended period of time. the instructions, may cause harmful interference to radio or television reception, which can be • Remove used batteries promptly. determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ELECTRICAL RATINGS • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. 125 V ac, 60Hz, • Connect the equipment into an outlet on a circuit different from that to which the receiver is 15 A Resistive, 15 A General Use, 1000W Tungsten, connected. 500 VA Electronic Ballast, 1/2 HP, • Consult the dealer or an experienced radio/TV technician for help. 120 Vac, 60Hz, 8.3 A Ballast. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two RECEIVER MODEL: RC-052 conditions: (1) This device may not cause harmful interference, and (2) this device must accept TRANSMITTER MODEL: TR-026A any interference received, including interference that may cause undesired operation. FCC ID: PAGTR-026A IC: 4494A-TR026A FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Industry Canada statement: This Class B digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Declaration De La FCC Concernant Le Brouillage Cet appareil a été testé et déclaré conforme aux limites imposées aux appareils numériques de classe B, conformément à l’alinéa 15 du règlement de la FCC. Ces limites sont destinées à assurer une protection raisonnable contre les interférences nuisibles dans un environnement résidentiel. Cet appareil génère, utilise et peut émettre de l’énergie radiofréquence et, s’il n’est pas installé et utilisé conformément aux instructions, risque de provoquer des interférences nuisibles aux communications radio. Cependant, tout risque d’interférence ne peut être Battery Handling and Usage totalement exclu. Si l’utilisateur constate des interférences lors de la réception d’émissions de radio ou de télévision (il suffit pour le vérifier d’allumer et d’éteindre successivement l’appareil), WARNING: Keep batteries away from children and pets. il devra prendre les mesures nécessaires suivantes pour les éliminer : • Follow the battery manufacturer’s safety and usage instructions. • Réorienter ou déplacer l’antenne réceptrice. • Insert the battery observing the proper polarity (+/-) as indicated inside the Battery • Accroître la distance entre l’appareil et le récepteur Zapin. Compartment. • Brancher l’appareil sur une prise de courant connectée à un circuit autre que celui du • Remote a spent or discharged battery from the product. remove the battery when not using récepteur. the product for an extended period. • Chercher de l’aide auprès du détaillant ou d’un technicien en radio ou en télévision • Never throw batteries into a fire. Do not expose batteries to fire or other heat sources. expérimenté. • Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste. • Dispose or recycle spent / discharged batteries in compliance with all applicable laws. For Made in China detailed information contact your local solid waste authority. SAVE THIS INSTRUCTION!


Document Created: 2019-05-20 19:07:26
Document Modified: 2019-05-20 19:07:26
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC