Users Manual

FCC ID: P27SBTC1

Users Manual

Download: PDF
FCCID_4471816

Smartbrief Quick Guide 1. Grab a new Smartbrief, fold over the front - Fold about 2” of the front edge outwards - Makes sure black lines are straight - Tabbed end goes on resident’s back side 2. If the transmitter was not in use, wake it up by attaching it to the new brief * - Align the transmitter lines with brief lines - Hold tightly until the light flashes to wake it up - No need to lock the latch - Take the transmitter off afterwards * Skip this step if you are changing the brief 3. Put the brief on the resident & attach the transmitter - Align the transmitter lines with brief lines - Hold tightly until the light flashes once - Push the latch down all the way to lock it - Double-check the alignment 4. Confirm “Dry” status on the dashboard. support@nearhealth.com

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: The product comply with the US portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Country Code selection feature to be disabled for products marketed to the US/CANADA This equipment should be installed and operated with minimum distance 0cm between the radiator & your body.


Document Created: 2019-10-08 10:28:46
Document Modified: 2019-10-08 10:28:46
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC