Correspondence

FCC ID: OWWC27G-CPAL-AB-C

Cover Letter(s)

Download: PDF
FCCID_2444292

CB-7.2.1 – Technical Review RT Form FCC ID: OWWC27G-CPAL-AB-C IC ID: CT Project: P1480008 From: Shawn McMillen Date: 11/06/2014 1--The internal photos show that this EUT uses RF shields however there is no internal photo demonstrating this with the shields installed. 11/11/14 – Hauptec provided. 2--Please note that the MPE needs to be calculated at a separation distance of 20.0cm not 20.3cm. 11/11/14 – Hauptec provided. 3--Please note that the conducted spurious emission >1GHz are relative to a 1MHz RBW however a lower RBW can be used as long as the power is integrated over 1MHz. Please see conducted band edge plot in the EMC report. CT (Mike G): The 300 kHz and 3 MHz frequency spans are included in the OOBE test procedure to verify compliance to the OOBE limits, both within the 1st 100KHz/1MHz from the band edge, where specific rules permit narrower RBWs to be used (i.e. 1% emissions bandwidth), and outside the 1st 100KHz/1MHz (i.e. up to 300kHz/3MHz) from the band edge, where the RBW must use 100 kHz or 1 MHz to comply with the regulatory OOBE limits. CT - Response by: Submitted by: Date: Form: CB-7.2.1 Issued by: QM Issue Date: 9/22/2011 Page 1 of 1 Revised by: QM-JS Revised Date: 6/23/2014 L:\Project\2014\p1480004-Huaptec\TCB Folder\RT's\CB-7.2.1 - Technical Review RT Form.docx


Document Created: 2014-11-14 00:45:29
Document Modified: 2014-11-14 00:45:29
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC