MPE Colocation Report

FCC ID: OWS-NIC514

RF Exposure Info

Download: PDF
FCCID_1377724

Permissive change request for Silver Spring Networks

Product: 902-928 MHz FHSS/2.4 GHz DTS radio module for electric meters
FCC ID: OWS-NIC514
Nature of change: To permit co-location with other Silver Spring meter modules




For most installations, electric meters using Silver Spring Networks radio modules are
single installations, one meter on an exterior residential wall being the most common
example. For some apartment installations, the electric meters for all the individual
apartments are mounted on the same wall in a meter room or closet.


In the meter room configuration, a meter module antenna will be co-located with the
meter module antenna to its right and to its left, because the minimum separation distance
is 16 cm, less than the 20cm distance defining non-co-located configurations. All other
meter antennas in the same row will be at least 32cm away so they are not co-located.
The meter antennas on the rows above and below any particular meter are not co-located
either, as the separation distance is 30 cm or more.



                                          16cm              16cm




                  (d2c + 162)0.5 cm


                                                     d cm


At a point located a distance d from a meter module antenna, the power density is the
sum of the contributions from the center meter and the two adjacent meters. Each
adjacent meters is further away, at a distance of (d2c + 162)0.5 cm, and therefore will
contribute less power density at d for the same transmitter eirp.


Meter Room Configuration Example


Horizontal Separation




Silver Spring Networks manufactures a number of radio modules that can be used in
electric meters. Any of these modules may be used in different combinations in an
apartment meter room. The operating output power and antenna gain for highest eirp,
and 20 cm power densities of the different modules, are listed below.

Module            Operating          Pout     Antenna             MPE, cm       S @ 20cm,
FCC ID:           Mode               Max.,dBm gain, dBi                         mW/cm2
OWS-NIC514        900 MHz            29.86    4                   18            0.48
                  FHSS
                  2.4 GHz DTS        20.8          3              4.4           0.05

OWS-NIC511        900 MHz            29.86         4              18            0.48
                  FHSS

OWS-NIC509        900 MHz            29.56         2.4            14.4          0.31
                  FHSS

OWS-NIC508        900 MHz            29.56         2.4            14.4          0.31
                  FHSS
                  900 MHz DTS        25.3          2.4            8.9           0.12
                  2.4 GHz DTS        23.56         1.5            5.2           0.07

OWS-NIC507        900 MHz            29.56         2.4            14.4          0.31
                  FHSS
                  2.4 GHz DTS        23.5          1.5            5.2           0.07

a. For FCC ID: OWS-NIC514, for 900 MHz operation, the worst-case configuration would be
for both adjacent meters to be either OWS-NIC514 or OWS-NIC511, as they both produce the
maximum product line power density of 0.48 mW/cm2 at 20 cm.

MPE calculations show that for a separation d = 29 cm from the center meter, the power density
is 0.58 mW/cm2, less than the maximum allowed 0.6 mW/cm2.

b. For FCC ID: OWS-NIC514, for 2.4 GHz operation, RF exposure calculations show that
maximum MPE distance from the center meter will be less than 21 cm worst-case with adjacent
meters producing maximum product line power density of 0.48 mW/cm2 at 20 cm.

Therefore, the MPE distance for co-located configuration of FCC ID: OWS-NIC514
will be 29cm.



Document Created: 2010-11-15 19:45:12
Document Modified: 2010-11-15 19:45:12

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC