Manual

FCC ID: OUT-CEREMPIR

Users Manual

Download: PDF

FCCID_1099160

PIR Sensor
(Placed on the wall)

CEREMPIR
User Manual

Place CEREMPIR on the wall where can be detected the movement in the room
widely. A signal will be sent to control, if there is a movement which will be detected
by CEREMPIR. User will be alerted if the movement inside the building.

The PIR Sensor equipped with case tamper detection. If the cover sensor is removed,
the PIR sensor will report a zone tamper to the control module

The PIR sensor is designed with cover tamper to avoid sensor remove and Pet Mode
switch to avoid false alarm.

z PRODUCT SPECIFICATION
Operating Frequency: 433.92MHz+/-150K
Operating Temperature: -20 to 40 C (-4 to 104 F)_
Battery: 3*Energizer AAA E92 1.5V Alkaline battery
Battery Life: 1 year (under normal usage)
Dimensions (W*H*D): 71*100*28mm
Type of Modulation: ASK
Tamper Switch

z BATTERY REPLACEMENT
Remove the cover by unscrewing. Use care when installing the battery and observe
the correct polarity. Use ONLY the Energizer AAA alkaline battery. Please wait for 90
seconds to put the battery on after it takes off for better usage.

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
[1] this device may not cause harmful interference and
[2] this device must accept any interference received, including
interference that may cause undesired operation.
S/N：
Made in Taiwan

Document Created: 2009-04-17 09:20:26
Document Modified: 2009-04-17 09:20:26

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC