RF Exposure Info

FCC ID: OU9LS405-B02

RF Exposure Info

Download: PDF
FCCID_3534058

SGS—CSTC Standards Technical Services Co., Ltd. Guangzhou Branch 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technological — Development District, Guangzhou, China 510663 Report No.: GZEM1707004280CR Telephone: +86 (0) 20 82155555 Page; 1 of 2 Fax: +86 (0) 20 82075059 Email: ee. guangzhou@sgs.com FCC ID: OU9LS405—BO2 1 RF Exposure Compliance Requirement The product belongs to standalone portable device base the FCC rule part 2.1091&2.1093. The transmission frequencies of the device are between 100 MHz and 6 GHz. The worst case test separation distance is 5mm. 2 SAR Evaluation 2.1 RF Exposure Compliance Requirement 2.1.1 Standard Requirement According to KDB447498D01 General RF Exposure Guidance v06 4.3.1. Standalone SAR test exclusion considerations Unless specifically required by the published RF exposure KDB procedures, standalone 1—g head or body and 10—g extremity SAR evaluation for general population exposure conditions, by measurement or numerical simulation, is not required when the corresponding SAR Exclusion Threshold condition, listed below, is satisfied. 2.1.2 Limits The 1—g and 10—g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances < 50 mm are determined by: [{max. power of channel, including tune—up tolerance, mW)/({min. test separation distance, mm)] : [Vf(GHz)] < 3.0 for 1—g SAR and < 7.5 for 10—g extremity SAR, where f(GHz) is the RF channel transmit frequency in GHz Power and distance are rounded to the nearest mW and mm before calculation‘‘ The result is rounded to one decimal place for comparison The test exclusions are applicable only when the minimum test separation distance is < 50 mm and for transmission frequencies between 100 MHz and 6 GHz. When the minimum test separation distance is < 5 mm, a distance of 5 mm is applied to determine SAR test exclusion 2.1.3 EUT RF Exposure This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at hftp://www.sqs.com/en/Terms—and—Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http:/www.sgs.com/en/Terms—and—Conditions/Terms—e—Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this documentis advised that information contained hereon reflects the Company‘s findings at the time of its intervention only and within the limits of Client‘s instructions, if any. The Company‘s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only.

SGS—CSTC Standards Technical Services Co., Ltd. Guangzhou Branch 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technological Report No.: GZEM1707004280CR Development District, Guangzhou, China 510663 Telephone: +86 (0) 20 82155555 Page; 2 of 2 Fax: +86 (0) 20 82075059 Email: ee. guangzhou@sgs.com FCC ID: OU9LS405—BO2 The Max Conducted Peak Output Power is 0.34dBm in Middle channel(2.440GHz); The best case gain of the antenna is —4dBi. EIRP= 0.34dBm + (—4dBi) = —3.66dBm —3.66dBm logarithmic terms convert to numeric result is nearly 0.431mW According to the formula. calculate the EIRP test result: [{max. power of channel, including tune—up tolerance, mW)/({min. test separation distance, mm)] : [v¥f(GHz)] General RF Exposure = (0.431mW /5 mm ) x v2.440GHz = 0.1346 ® SAR requirement: S= 3.0 G : 0 < . So the SAR report is not required. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at hftp://www.sqs.com/en/Terms—and—Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http:/www.sgs.com/en/Terms—and—Conditions/Terms—e—Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this documentis advised that information contained hereon reflects the Company‘s findings at the time of its intervention only and within the limits of Client‘s instructions, if any. The Company‘s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only.


Document Created: 2017-08-21 03:05:53
Document Modified: 2017-08-21 03:05:53
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC