Modular Approval Letter

FCC ID: OSGZBM

Cover Letter(s)

Download: PDF
FCCID_1758809

MODULAR APPROVAL LETTER OR LIMITED MODULAR APPROVAL LETTER FCC ID: OSGZBM Item Requirements EUT 1 The modular transmitter must have its own RF Radio part is covered with its own RF shielding. shielding The EUT shall be sold to OEM integrators and manufacturers for installation in a specific host device. The OEM manufacturer or OEM integrator shall use comply with the FCC rules. The OEM manufacturer or OEM integrator shall apply for new FCC ID certification of the final product with the help of this limited approved module design. 2 The modular transmitter must have buffered The modular transmitter has buffered modulation/data inputs. modulation/data inputs. 3 The modular transmitter must have its own power Equipment is built into. supply regulation. 4 The modular transmitter must comply with the The modular transmitter use chip antenna. It antenna and transmission system requirements of complied requirements of15.203, 15.204(b), sections 15.203, 15.204(b) and 15.204(c) 15.204(c). 5 The modular transmitter must be tested in a stand- It tested in a stand-alone configurati alone configuration, i.e., the module must not be inside another device during testing. This is intended to demonstrate that the module is capable of complying with Part 15 emission limits regardless of the device into which it is eventually installed. 6 The modular transmitter must be labeled with its Module is labeled with its own FCC ID: own FCC ID number, and, if the FCC ID is not OSGZBM visible when the module is installed inside another device, then the outside of the device into (Add the following information in the user which the module is installed must also display a manual of FCC ID: OSGZBM) label referring to the enclosed module. This exterior label can use wording such as the If the FCC ID is not visible when the module is following: "Contains Transmitter Module FCC installed inside another device, then the ID: XYZMODEL1" or "Contains FCC ID: XYZMODEL1." Any similar wording that outside of the device into which the module is expresses the same meaning may be used. The installed must also display a label referring to Grantee may either provide such a label, an the enclosed module. This exterior label shall example of which must be included in the be: "Contains FCC ID: XXXYYYYYYY application for equipment authorization, or, must provide adequate instructions along with the module which explain this requirement. In the latter case, a copy of these instructions must be included in the application for equipment authorization 7 The modular transmitter must comply with any If the test report is compliant, then refer to the specific rule or operating requirements applicable test report and declare that this point has been to the transmitter and the manufacturer must

provide adequate instructions along with the fulfilled. module to explain any such requirements. 8 The modular transmitter must comply with any It wrote on report. applicable RF exposure requirements.


Document Created: 2012-08-03 11:54:02
Document Modified: 2012-08-03 11:54:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC