User Manual

FCC ID: OP5PL5561

Users Manual

Download: PDF

FCCID_1688536

$SKAA User’s Manual For all SKAA part numbers including PL5553, PL5554, PL5556 and PL5561 SKAATM transmitters each support up to four SKAA receiver units at the same time. The SKAA logo guarantees compatibility between transmitters and receivers. Green List ‐ All SKAA receivers have a Green List which is just a list of your favorite transmitters. The first time you use a receiver, the Green List is empty, so you need to Double Click the SKAA button to hunt for a new transmitter. If your receiver consists of two or more wireless units, (for example, a left speaker and a right speaker) we call that a Cluster. The unit with the SKAA button is the Master of the Cluster and it is where the Green List is kept. Each unit uses three LED colors to communicate SKAA status: green, amber and red. TM SKAA is a trademark of Eleven Engineering Incorporated. Please visit www.SKAA.com. Common SKAA Commands Command Button LED Hunt through Green List (look for favorite Single Click Hunting transmitters) (Flash) Green List # Bonded Explore; hunt for new transmitters Double Click Hunting Bonded Add / delete transmitter from Green List Hold for 3 seconds Æ Added (Flash) Deleted Automatically add transmitter to Green List by ‐ Æ Added listening continuously for 30 minutes. More SKAA Commands Command Button LED When hunting through green list, stop at the Single Click Hunting current green list entry and continue to look solely (Flash) Green List # for that transmitter Bonded Mute Triple Click Flashing If muted, unmute Single Click Returns to previous Erase the Green List; start over Click 6 times Flashes To make a Cluster of receivers: Hold during power on. (Flashing) Master has 1. power on Master while holding down SKAA entered cluster up button (hold button until red LED starts Note ‐ only receiver units mode flashing) from the same manufacturer 2. power on remaining receiver units and product family may Cluster has been become a Cluster 3. once LED on Master becomes solid (stops successfully made flashing), turn off the Master and all other receiver units FCC Statement: Federal Communication Commission Interference Statement IC Statement This Class B digital apparatus complies with Canadian ICES-003. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 7KLVGHYLFHFRPSOLHVZLWK,QGXVWU\&DQDGDOLFHQVHH[HPSW566VWDQGDUG V FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in any interference, including interference that may cause undesired operation of the device. accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or Cet appareil numérique de la classe B est conforme á la norme NMB-003 du Canada. television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de • Consult the dealer or an experienced radio/TV technician for help. l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.$

Document Created: 2019-09-03 16:15:23
Document Modified: 2019-09-03 16:15:23