Module Letter

FCC ID: O6RFIT1

Cover Letter(s)

Download: PDF
FCCID_1111577

ROGERS LABS, INC. 4405 West 259th Terrace Louisburg, KS 66053 Phone / Fax (913) 837-3214 May 13, 2009 Timco Engineering Inc. Federal Communications Commission 849 NW State Road 45 Equipment Approval Services Newberry, FL 32669 P.O. Box 35815 Pittsburgh, PA 15251-3315 Applicant: DYNASTREAM INNOVATIONS, INC. 228 River Avenue Cochrane, Alberta Canada T4C 2C1 Equipment: FCC ID: O6RFIT1 FCC Rules: Part 2 and 15.247 (Single Modular Low Power Transmitter) Re: Single modular transmitter approval Gentlemen: As requested in the Public Notice DA00-1407 regarding Part 15 unlicensed modular transmitter approval, the following information has been addressed. The transmitter module is a complete RF transmitter containing its own reference oscillator, antenna etc. The connections available on the module are for power and data interface. Below please find information, addressing each paragraph from DA00-1407, requested about the unit. 1.) The unit has shield effectively preventing coupling between the RF circuitry of the module and any wires or circuits in the device into which the module is installed. Photographs of the unit are included in an exhibit with the application. 2.) The unit incorporates a buffer stage on the inputs to limit over-modulation. 3.) The unit has power regulation incorporated in the circuitry to ensure continued compliance regardless of the design of the power supplying circuitry. 4.) The unit utilizes a unique antenna configuration embedded in the printed circuit board and complies with the antenna requirements. 5.) The module was tested while placed in the open and attached to a development interface board supplying data and power. The module complies with part 15 emissions limits regardless of the device into which it is eventually installed. 6.) The module has the FCC ID number permanently affixed to the equipment and instruction offered about required information placement on the exterior of enclosures in which the equipment is contained. 7.) The unit complies with CFR47 regulations as stated in the user manual. Adequate instructions are supplied with the unit to explain requirements. 8.) The unit complies with the RF exposure requirements as stated in 2.1091, 2.1093, and part 15. Should you require any further information, please contact the undersigned. Thank you for your consideration in this matter. Sincerely, Scot D. Rogers Rogers Labs, Inc.


Document Created: 2009-05-13 08:17:11
Document Modified: 2009-05-13 08:17:11
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC