Users Manual

FCC ID: NTAWB1

Users Manual

Download: PDF
FCCID_821590

101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 Dialog - Booster Installation Instructions Field Operations Factory Default Parameters Magnet Position the magnet on the Booster Status FH Tx On initialization Booster cone for 3 Buzzer On seconds Magnet activation On Learning the Pit Install the Booster into the 3G Meters pit within 30 seconds Booster is Ready This process is done to Transmit automatically. After 5-6 Magnet minutes The Booster is Positioning ready to transmit FCC ID: NTAWB1 The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment. ATTENTION: The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1.) Reorient or relocate the receiving antenna. 2.) Increase the separation between the equipment and receiver. 3.) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4.) Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: Dialog Booster is designed only for Master Meter meters with Dialog registers.

101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 Installation 3G Meter in a Pit-set to be learned by Booster Insert and Install the Booster into the Pit-Set Lid Locate the Booster Unit near the Pit-Set Position the assembled Pit-Set Lid with the Face the Magnet on the Booster Cone Booster unit back on the Pit Wait for 3 seconds until its Beep (After the Beep)


Document Created: 2007-07-05 13:38:57
Document Modified: 2007-07-05 13:38:57
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC