User Manual

FCC ID: NT8-TX9

Users Manual

Download: PDF
FCCID_739912

Using the remote control USING THE REMOTE 4. Approach lighting. CONTROL 5. Emergency alarm. 6. Key blade release tab. Remote control 7. Key blade. WARNING FCC and Canadian warning Never leave the remote control statement in the vehicle if children or This device complies with part 15 of animals are also left in the vehicle. the FCC rules. The vehicle's systems and remote control functions could be operated, Operation is subject to the following which may result in injury. two conditions: 1. This device may not cause Note: The operational range of the harmful interference, and remote control will vary considerably 2. this device must accept any depending on atmospheric interference received, including conditions and interference from interference that may cause other transmitting devices. undesired operation. The vehicle is supplied with two Any changes or modifications not remote controls, but up to six can be expressly approved by the party programmed to the vehicle at any responsible for compliance could one time. void the user’s authority to operate the equipment. This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference, including interference that may cause undesired operation of the device. Transmitter FCC ID: NT8-TX9 IC : 3043A-TX9 1. Unlock. 2. Lock. 3. Tailgate release. 1

Using the remote control Unlocking Automatic relocking Press briefly to unlock the If a door, or the tailgate, are not vehicle, and deactivate the opened within one minute of alarm. The hazard warning unlocking the vehicle, doors will lock lamps will flash twice to indicate that again automatically. the vehicle is unlocked and the alarm has been deactivated. The interior Approach lighting lamps will illuminate to assist entry to When approaching the the vehicle. vehicle during darkness press to switch on the Single/Multi-point entry approach illumination. Press again to turn the approach lamps off. When you press the unlock button your vehicle will unlock in one of two The approach illumination ways: period set at the factory is 1. Unlock the driver's door only. A thirty seconds. This can be second press is required to unlock configured by a Land Rover Dealer the remaining doors and tailgate. to provide illumination lasting between Zero and 120 seconds. 2. Unlock all doors, and the tailgate. This security feature unlocks only the Tailgate driver’s door and tailgate. It can be disabled on individual remote controls Press briefly to release the by unlocking the vehicle then tailgate. simultaneously pressing and holding the lock and unlock buttons for three Emergency alarm seconds. The vehicle will lock and then unlock in the currently selected Press and hold for three mode and the hazard warning lights seconds, or press twice will flash twice to confirm the change. within three seconds, to You can now unlock all doors with a activate the horn and the hazard single press. Repeating the lamps. procedure will re-enable Single point entry. Once active for more than five seconds the alarm can be cancelled Locking by pressing the button and holding for three seconds, or pressing twice Press briefly to lock the within three seconds. vehicle, and activate the alarm. The hazard warning Note: The horn and hazard lamps lamps will flash to indicate that the will switch off automatically after two vehicle is locked. minutes and forty five seconds. 2

Using the remote control Remote battery The remote control batteries are recharged when the remote is docked and the engine is running. For this reason it is recommended that each remote is used periodically. This will ensure that the batteries are kept charged and ready for use. 3


Document Created: 2006-11-02 13:35:19
Document Modified: 2006-11-02 13:35:19
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC