SAR Report 5 of 6

FCC ID: NM8PD29130

RF Exposure Info

Download: PDF
FCCID_1385149

FCC SAR Test Report Report No. : FA0O2613A Appendix E. FCC 3G SAR Measurement Procedures Conducted Output Power: The EUT was tested according to the requirements of the FCC 3G procedures and the TS 34.121. The EUT's WCDMA and HSPA function is Release 6 version supporting HSDPA Category 8, and HSUPA Category 5. A detailed analysis of the output power for all WCDMA, HSPDA, and HSPA (HSUPA & HSDPA) modes is provided in the tables below. According to the FCC 3G procedures, handsets with both HSDPA and HSUPA should be tested according to Release 6 HSPA test procedures. Device was tested according to procedure KDB941225 - section Release 6 HSPA Data Devices as documented/evaluated in the following table. WCDMA SAR Test mode - Conducted Power Cell band (850) PCS band (1900) CH4132 CH4182 CH4233 CH9262 CH9400 CH9538 Mode Setup 826.4 836.4 846.6 1852.4 1880.0 1907.6 (MHz) (MHz) (MHz) (MHz) (MHz) (MHz) WCDMA RMC 12.2Kbps 22.45 22.20 22.25 22.51 22.26 22.29 Subtest 1 22.40 22.19 22.19 22.41 22.19 22.22 Subtest 2 22.26 21.95 21.97 22.32 22.11 22.19 HSDPA Subtest 3 21.75 21.52 21.62 21.55 21.23 21.26 Subtest 4 21.81 21.46 21.35 21.55 21.18 21.26 Subtest 1 22.16 22.00 21.61 22.25 21.93 21.85 Subtest 2 19.93 19.96 19.45 20.86 20.77 20.94 HSUPA Subtest 3 20.88 20.81 20.74 21.43 21.21 21.27 Subtest 4 20.88 20.39 20.85 21.05 20.68 20.78 Subtest 5 22.20 22.09 21.70 22.23 21.77 21.83 SPORTON INTERNATIONAL INC. Page Number : E1 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A WCDMA Setup Configuration: a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting i. Data rates: Varied from RMC 12.2Kbps ii. RMC Test Loop = Loop Mode 1 iii. Power Ctrl Mode = All Up bits d. The transmitted maximum output power was recorded. Setup Configuration SPORTON INTERNATIONAL INC. Page Number : E2 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A HSDPA Setup Configuration: a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting: i. Set Gain Factors (βc and βd) and parameters were set according to each ii. Specific sub-test in the following table, C10.1.4, quoted from the TS 34.121 iii. Set RMC12.2Kbps + HSDPA mode. iv. Set Cell Power = -86 dBm v. Set HS-DSCH Configuration Type to FRC (H-set 1, QPSK) vi. Select HSDPA Uplink Parameters vii. Set DeltaACK, DeltaNACK and DeltaCQI = 8 viii. Set Ack-Nack Repetition Factor to 3 ix. Set CQI Feedback Cycle (k) to 4 ms x. Set CQI Repetition Factor to 2 xi. Power Ctrl Mode = All Up bits d. The transmitted maximum output power was recorded. Setup Configuration SPORTON INTERNATIONAL INC. Page Number : E3 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A HSPA (HSUPA & HSPDA) Setup Configuration: a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting * : i. Call Configs = 5.2B, 5.9B, 5.10B, and 5.13.2B with QPSK ii. Set the Gain Factors (βc and βd) and parameters (AG Index) were set according to each specific sub-test in the following table, C11.1.3, quoted from the TS 34.121 iii. Set Cell Power = -86 dBm iv. Set Channel Type = 12.2k + HSPA v. Set UE Target Power vi. Power Ctrl Mode= Alternating bits vii. Set and observe the E-TFCI viii. Confirm that E-TFCI is equal to the target E-TFCI of 75 for sub-test 1, and other subtest’s E-TFCI d. The transmitted maximum output power was recorded. Setup Configuration Note: For details settings in the Agilent 8960 test equipment, please refer to the user guide “ HSUPA Measurement Guide with 8960 V7.5.0 Release 7 (2007-06) Ver.: v.02.18” SPORTON INTERNATIONAL INC. Page Number : E4 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A Example for HSPA Subtest 1, and other subtests following table, C11.1.3 (Gain Factors (βc = 11 and βd = 15)) Example: AG – Index = 20 for HSPA subtest 1 SPORTON INTERNATIONAL INC. Page Number : E5 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A Example: Confirm that E-TFCI is equal to the target E-TFCI of 75 for sub-test 1 SPORTON INTERNATIONAL INC. Page Number : E6 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130

FCC SAR Test Report Report No. : FA0O2613A Reference: [1] 941225 D01 SAR test for 3G devices v02, SAR Measurement Procedures for 3G Devices CDMA 2000/Ev-Do/WCDMA/HSDPA/HSPA Oct. 2007 Laboratory Division Office of Engineering and Technology Federal Communications Commission [2.] TS 34.121 Universal Mobile Telecommunications System (UMTS); Terminal Conformance Specification, Radio Transmission and Reception (FDD) [3.] HSUPA Measurement Guide with 8960 V7.5.0 Release 7 (2007-06) Ver.: v.02.18 SPORTON INTERNATIONAL INC. Page Number : E7 of E7 TEL : 886-3-327-3456 Report Issued Date : Nov. 23, 2010 FAX : 886-3-328-4978 Report Version : Rev. 01 FCC ID : NM8PD29130


Document Created: 2010-11-25 15:30:29
Document Modified: 2010-11-25 15:30:29
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC