CONDUCTED OUTPUT POWER

FCC ID: NM8DM

RF Exposure Info

Download: PDF
FCCID_976366

FCC/IC SAR Test Report Test Report No : FA811107-01-A Conducted Output Power The EUT was tested according to the requirements of the FCC 3G procedures and the TS 34.121. The EUT's WCDMA and HSPA function is Release 6 version supporting HSDPA Category 8, and HSUPA Category 5. A detailed analysis of the output power for all WCDMA, HSPDA, and HSUPA modes is provided in the tables below. According to the FCC 3G procedures, handsets with both HSDPA and HSUPA should be tested according to Release 6 HSPA test procedures, and the EUT does not support VOIP function over the HSPA function. The HSPA output levels are less than ¼ dB higher than the basic 12.2 kbps RMC configurations in WCDMA, as required by FCC 3G SAR procedures, HSPA SAR is not needed and the PBA is fulfilled. Band II Band V Symbol Reference Ch Ch Ch Ch Ch Ch Mode Rates SF K Data Channel Type 9262 9400 9538 4132 4182 4233 (Kbps) (Data Rates) 1852.4 1880.0 1907.6 826.4 836.4 846.6 60 64 2 40 RMC 12.2 Kbps 22.55 22.65 22.46 23.48 23.68 23.50 240 16 4 160 RMC 64 Kbps 22.60 22.54 22.33 23.60 23.73 23.60 DPDCH1 480 8 5 320 RMC 144 Kbps 22.57 22.72 22.40 23.61 23.78 23.61 960 4 6 640 RMC 384 Kbps 22.59 22.74 22.43 23.61 23.57 23.63 HSDPA-Subtest1 60 64 2 40 RMC 12.2 Kbps 21.74 21.99 21.85 22.85 22.86 22.88 Data: Bits/Slot; SF: Spreading Factor; K: Number of bits per uplink DPDCH slot. Table 1 Conducted output power for WCDMA Band WCDMAⅡ-1900 WCDMAⅤ-850 Mode Sub-test Channel 9262 9400 9538 4132 4182 4233 1 βc(2/15) 21.74 21.99 21.85 22.85 22.86 22.88 2 βc (12/15) 21.68 22.06 21.86 22.68 22.83 22.59 R5-HSDPA 3 βc (15/15) 22.12 22.56 21.14 23.01 23.16 22.66 4 βc (2/15) 21.74 22.14 21.07 22.14 22.3 22.05 Table 2 Conducted output power for HSDPA Band WCDMAⅡ-1900 WCDMAⅤ-850 Mode Sub-test Channel 9262 9400 9538 4132 4182 4233 1 βc (11/15) 19.16 19.40 22.18 23.14 23.35 23.12 2 βc (6/15) 22.85 23.07 22.80 23.79 24.00 23.69 R6-HSUPA 3 βc (15/9) 22.25 22.61 22.44 23.28 23.64 23.29 4 βc (2/15) 22.86 23.27 22.95 23.96 24.25 23.86 5 βc(15/15) 22.51 22.68 22.46 23.33 23.50 23.29 Table 3 Conducted output power for HSUPA ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 Followed by FCC suggestions [1]: The parameter K in the figure determines the number of bits per uplink DPDCH slot. It is related to k the spreading factor SF of the DPDCH as SF = 256/2 . The DPDCH spreading factor may range from 256 down to 4. The spreading factor of the uplink DPCCH is always equal to 256, i.e. there are 10 bits per uplink DPCCH slot. Table 2 DPCCH and DPDCH There is only one DPCCH per radio link. Data rates, channelization codes and spread factor information for DPCCH and DPDCHn are indicated in the following Table. Spreading Rate (SF) * Symbol Rate = 3.84 Mcps. ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 WCDMA Setup Configuration: a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting i. Data rates: Varied from RMC 12.2Kbps to 384Kbps for each measurement. ii. RMC Test Loop=Loop Mode 1 RLC TM iii. TPC with All Up. d. The transmitted maximum output power was recorded. Setup Configuration ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 Single DPCCH with only one DPDCH at RMC 12.2Kbps (Symbol Rate 60 Kbps) TPC with All “ 1” (Continuous transmitting ) ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 HSDPA Setup Configuration a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting: i. Set RMC12.2Kbps with HSDPA mode. ii. RMC Test Loop=Loop Mode 1 RLC TM iii. TPC with All Up iv. Channel Configuration Type=FRC with H-set 1 (QPSK) v. CQI Feedback Cycle=4ms, CQI Repetition Factor=2 vi. RV Coding Sequence {0.2.5.6} vii. Gain Factors(βc,and βd) and parameters were set according to each specific sub-test in the following table, C10.1.4, quoted from the TS 34.121. d. The transmitted maximum output power was recorded. ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 RMC 12.2Kbps with HSDPA function HSUPA Setup Configuration a. The EUT was connected to Base Station referred to the drawing of Setup Configuration. b. The RF path losses were compensated into the measurements. c. A call was established between EUT and Base Station with following setting: i. Set HSUPA mode. ii. RMC Test Loop=Loop Mode 1 RLC TM iii. Power control algorithm 2 iv. HS-DSCH Channel Configuration Type=FRC with H-set 1 (QPSK) v. Gain Factors (βc,and βd)and parameters were set according to each specific sub-test in the following table, C11.1.3, quoted from the TS 34.121. d. The transmitted maximum output power was recorded. ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 HSUPA function ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03

FCC SAR Test Report Test Report No : 錯誤! 找不到參照來源。 Reference: [1.] 941225 D01 SAR test for 3G devices v02, SAR Measurement Procedures for 3G Devices CDMA 2000/Ev-Do/WCDMA/HSDPA/HSPA Oct. 2007 Laboratory Division Office of Engineering and Technology Federal Communications Commission [2.] TS 34.121 Universal Mobile Telecommunications System (UMTS); Terminal Conformance Specification, Radio Transmission and Reception (FDD) [3.] Operation Guide for HSUPA Test Set-up According to 3GPP TS 34.121 written by Rohde & Schwarz RCS-07 12-0053 ©2008 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 03


Document Created: 2008-07-25 21:53:29
Document Modified: 2008-07-25 21:53:29
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC