Modul Appr Lett

FCC ID: NKR-SWA6

Cover Letter(s)

Download: PDF
FCCID_1367261

Wistron NeWeb Corporation
20 Park Avenue II, Hsinchu Science Park, Hsinchu 308, Taiwan, R.O.C.
Tel:886-3-6667799
Fax:886-3-6667323


               Request for transmitter Full Modular Approval

Transmitter Module Characteristics
Item Requirements EUT
1 Yes Have its own RF shielding              Have its own RF shielding
                                             Please refer to Photos

2 Yes Have buffered modulation/data         Have buffered modulation/data
      inputs (if such inputs are provided), inputs,
                                            Please refer to block diagram and
                                            schematic
3 Yes Have it own power supply regulation Have it own power supply regulation
                                          Please refer to block diagram and
                                          schematic
4 Yes Meet the antenna requirements of       Meet the antenna requirements of
      Section 15.203                         Section 15.203
                                             Show antenna information

5 Yes Be tested in a stand-alone             Please refer to test setup photos
      configuration, i.e., the antenna, AC
      or DC power and data input/output
      lines must be connected to the
      module but, the module must not be
      inside another case during testing


6 Yes Be labeled with its own FCC ID        Be labeled with its own FCC ID
      number, and if the FCC ID is not      number
      visible when the module is installed Please refer to Label information
      inside another device, then the
      outside of the device into which the
      module is installed must also display
      a label referring to the enclosed
      module.
7 Yes The modular transmitter must
      comply with any specific rules or      Please refer to User manual ,
      operating requirements that          There are no adjustable components
      ordinarily apply to a complete       in the RF section
      transmitter and the manufacturer
      must provide adequate instructions
      along with the module to explain any
      such requirements.
      A copy of these instructions must be
      included in the application for
      equipment authorization.
8 Yes Address compliance with the            The card-edge interface of the
      Commission's RF exposure limits in     module is proprietary and can only
      Sections 1.1310 and 2.1093.            be found on Rocketboost products
      In addition, spread spectrum           that qualify for mobile or stationary
      transmitters operating under Section   operation.
      15.247 are required to address RF      Please also refer to test report s.
      exposure compliance in accordance
      with Section 15.247(b)(4).




Certified By: __________________
Date: 2010.08.19



Document Created: 2010-08-19 15:15:03
Document Modified: 2010-08-19 15:15:03

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC