Modular Approval Request

FCC ID: N89-WM610P

Cover Letter(s)

Download: PDF
FCCID_656779

FCC ID: N89-WM610P



     Mobile Modular Approval Request Letter

Advance Data Technology
May. 11, 2006



Dear Application Examiner,


CyberTAN Technology, Inc.’s 54M WLAN Mini PCI Module, FCC ID: N89-WM610P,
would like to have your authorization as a mobile modular approval specific to the
Notebook Computer Access Point...etc.        The requirements of Public Notice DA00-
1407 have been met and shown on the following statements.

1. “The modular transmitter must have its own RF shielding.”: The radio portion of
   this module has been shielded, please see exhibition External Photo.

2. “The modular transmitter must have buffered modulation/data inputs.” The EUT
     has buffered data inputs, it is integrated in chip IPN2220.

3. “The modular transmitter must have its own power supply regulation.” The chips
     RF converter which will influence the frequency radiation, have to be 3.0V DC
     powered. The miniPCI interface provides 3.3VDC, so there are regulators in
     front of these chips, the part number of this regulator is AME8801BEEV.

4. “The modular transmitter must comply with the antenna requirements of section
     15.203 and 15.204(C).” The EUT meets the FCC antenna requirements. The
     spurious emission, unique antenna connector and photo of antennas are shown in
     the test report.

5. “The modular transmitter must be tested in a stand-alone configuration” The EUT
   was placed on an extended card which connected to Notebook Computer as a
   stand-alone configuration. The EUT was tested via the outside a Notebook
   Computer. Please see section Photographs of Test Configuration in the test
   report.

6.    “The modular transmitter must be labeled with its own FCC ID number.” Please
     see exhibition Label Sample for the FCC ID of this module. And also in the
     exhibition Users Manual, there are instructions give to the OEM on how to label
     the end product.




ADT No. 950503L22


FCC ID: N89-WM610P



7. “The modular transmitter must comply with any specific rule or operating
   requirements applicable to the transmitter and the manufacturer must provide
   adequate instructions along with the module to explain any such requirements.”
   The EUT is compliant with all applicable FCC rules. Detail instructions for
   maintaining compliance are given in the Users Manual.

8. “The modular transmitter must comply with any applicable RF exposure
   requirements.” The EUT is compliant with all applicable RF exposure
   requirements. RF Exposure is addressed in the RF exposure exhibition.



Please contact me if you have any further questions. Thanks for your attention.




Best Regards,




Eric Lin
Manager of Hsinchu Certification Service Div.
Advance Data Technology




ADT No. 950503L22



Document Created: 2006-05-11 13:58:54
Document Modified: 2006-05-11 13:58:54

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC