Modular Approval

FCC ID: N7NGTM2

Cover Letter(s)

Download: PDF
FCCID_1553217

       Sierra Wireless America, Inc
       2200 Faraday Ct. Ste. 150
       Carlsbad CA, 92008
       Tel. 760-476-8700
       Fax 760-476-8701

       FCC ID: N7NGTM2
                                     Request for transmitter modular approval

                                       Transmitter Module Characteristics

Item                                  Requirements                                                      EUT
  1      Have its own RF shielding                                                  Device is equipped with Metal shielding
                                                                                      to cover RF section. Refer to external
                                                                                                       photos
 2       Have buffered modulation/data inputs (if such inputs are provided),          All inputs to the modules are buffered
                                                                                     through logic or microprocessor inputs.
 3       Have its own power supply regulation                                       Internal 1.3V power regulator. Refer to
                                                                                                   Block diagram
 4       Meet the antenna requirements of Section 15.203                            Device is equipped with unique antenna
                                                                                        SMT pad. Refer to external photos
 5       Be tested in a stand-alone configuration, i.e., the antenna, AC or DC            Device was tested on a supplied
         power and data input/output lines must be connected to the module               development platform for limited
         but, the module must not be inside another case during testing             modular approval. Refer to setup photos.
 6       Be labeled with its own FCC ID number, and if the FCC ID is not               FCC ID label is placed on the metal
         visible when the module is installed inside another device, then the           shielding of the modem. Labeling
         outside of the device into which the module is installed must also        instruction has been provided in the OEM
         display a label referring to the enclosed module.                          installation instruction. Refer to FCC ID
                                                                                           label format and location file.
 7       The modular transmitter is manufactured so that the user cannot                     Reference “User’s Guide.
         influence the operation of the transmitter that will operate outside of
         the scope of the regulations.
 8       Address compliance with the Commission's RF exposure limits in                      MPE was calculated.
         Sections 1.1310 and 2.1091. In addition, spread spectrum transmitters
         operating under Section 15.247 are required to address RF exposure
         compliance in accordance with Section 15.247(b)(4).

       Sincerely,




       Todd Van Cleave
       Manager Engineering Services
       Carlsbad Research & Development
       Sierra Wireless America, Inc.



Document Created: 2010-11-01 10:56:51
Document Modified: 2010-11-01 10:56:51

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC