FCC MA Letter

FCC ID: N6C-SDMGN

Cover Letter(s)

Download: PDF
FCCID_2200919

                                                                                       S
                                                                                            m
                                                                                           #


                                                                                       t echnolog y



                                                                                       www. silex. jp
                                Request for Modular Transmitter Approval
                                                                                           February 20, 2014
FCC ID : N6C—SDMGN
Applicant: Silex Technology, Inc.

This transmitter, model: SX—SDMGN is designed by us.
It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section
15.212 as indicated below:

Modular Approval Checklist:
 Modular approval requirement                                              Yes   No
 (1) Have its own RF shielding.                                            [X    ]

 (2) Have buffered modulation/data inputs.                                 [     ]

 (3) Have its own power supply regulation.                                 [     ]

 (4) Comply with the antenna and transmission system requirements                [_]
 of § 15.203, 15.204(b) and 15.204(c).
 (5) Tested in a stand—alone configuration.                                [X    ]
 Unless the transmitter module will be battery powered, it must
 comply with the AC line conducted requirements found in FCC §
 15.207. AC or DC power lines and data input/output lines
 connected to the module must not contain ferrites, unless they will
 be marketed with the module. The length of these lines shall be the
 length typical of actual use or, if that length is unknown, at least 10
 centimeters to insure that there is no coupling between the case of
 the module and supporting equipment. Any accessories,
 peripherals, or support equipment connected to the module during
 testing shall be unmodified and commercially available.
 (6) Equipped with either a permanently affixed label or must be           [X    ]
 capable of electronically displaying its FCC ID.
 If the FCC ID is not visible when the module is installed inside
 another device, then the outside of the device into which the module
 is installed must also display a label referring to the enclosed
 module.
 (7) Comply with any specific rules or operating requirements that         [X]   ]
 ordinarily apply to a complete transmitter and the manufacturer
 must provide adequate instructions along with the module to
 explain any such requirements.
 (8) Comply with any applicable RF exposure requirements in its            [X]   []
 final configuration: The modular transmitter complies with FCC
 radiation exposure requirement.


                       ;       y
    /4       ’7’~
  s[rrr [<eorru Cy!*
Toshiro Kometani
Senior Manager
Silex Technology, Inc.



Document Created: 2014-02-20 17:36:47
Document Modified: 2014-02-20 17:36:47

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC