Users Manual

FCC ID: MG3-R32140B

Users Manual

Download: PDF
FCCID_3973472

How to setup your voice remote A. Make sure you are pointing your voice remote at the Set-Top Box you want to pair with. B. Press and hold the Play/Pause and 0 buttons at the same time for three seconds. Release when the blue light starts flashing on the remote. C. When the blue light stops flashing, your remote is connected and paired. D. Follow on-screen directions to pair the remote with your TV Give voice control a try. Hold the button down and say: “Tune to CNN” or “Show me comedy movies.” Or, click OK to go to Live TV. For support, select Report an Issue at www.xxxxx.com

FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.


Document Created: 2018-07-27 16:21:32
Document Modified: 2018-07-27 16:21:32
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC