Users Manual

FCC ID: MG3-43523

Users Manual

Download: PDF
FCCID_3934880

XR15 Voice Remote Control 1 Turn on your remote FCC Compliance Statement Your remote arrives with the AA batteries already installed, but This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC not activated. Here is how to power it on for the first time. rules. These limits are designed to provide reasonable protection 1. Pick up your remote and remove the “Pull” tab (on against harmful interference in a residential installation. This back) by pulling away from the remote. The Status LED equipment generates, uses, and can radiate radio frequency will blink green four times as the remote powers up energy and, if not used in accordance with the instructions, may (about 5 seconds). cause harmful interference to radio communications. 2. Turn on your TV. There is no guarantee that interference will not occur in a 3. Turn on your set-top box. particular installation. If this equipment does cause harmful interference to radio or television reception, the user is 2 Pair Your Remote for Voice Control encouraged to try to correct the interference by one or more of the following measures: Use voice control to search for networks and shows, set DVR • Reorient or relocate the receiving antenna. recordings, and get recommendations. See Step 5 of this guide • Increase or decrease the separation between the equipment and receiver. for examples. • Connect the equipment into an outlet on a circuit 1. Press and hold the Xfinity and Info buttons (about 5 different from that which the receiver is connected. seconds) until the Status LED changes from red to • Consult the dealer or an experienced remote control / green. TV technician for help. • It is strongly recommended that the TV be plugged into a separate wall outlet. 3 Control Your TV’s Power and Volume The user is cautioned that changes and modifications made to this Control the power, volume, and input of your TV using your equipment without the approval of the manufacturer could void the user’s authority to operate this equipment. Xfinity Remote. 1. Find the 5-digit code for your TV manufacturer. This device complies with part 15 of the FCC rules. Operation is 2. Press and hold the Xfinity and Info buttons (about 5 subject to the following two conditions: (1) This device may not seconds) until the Status LED changes from red to cause harmful interference, and (2) this device must accept any green. interference received, including interference that may cause undesired operation. 3. Enter the first 5-digit code for your TV manufacturer. The Status LED should flash green twice. 4. Verify that the code was accepted by using your remote to adjust volume and turn the TV on and off. 4 Test Voice Control Once your remote is paired with your set-top box, you can use voice control. 1. Press and hold the Voice button until you hear the audio tone. 2. Speak a voice command to the remote while continuing to hold down the button. The Status LED will be solid blue while you speak your command. 3. Release the Voice button when your command is complete. Look at the TV for the results of your voice command.


Document Created: 0550-06-01 00:00:00
Document Modified: 0550-06-01 00:00:00
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC